3.0Safety warnings
1.Read and understand the entire owner's manual before attempting assembly or operation.
2.Read and understand warnings posted on the machine and in this manual. Failure to comply with all of these warnings may cause serious injury.
3.Replace warning labels if they become obscured or removed.
4.The table saw on which this fence is used, is designed and intended for use by properly trained and experienced personnel only. If you are not familiar with the proper and safe operation of a table saw, do not use until proper training and knowledge have been obtained.
5.Do not use the table saw for other than its intended use. If used for other purposes, Walter Meier (Manufacturing) Inc., disclaims any real or implied warranty and holds itself harmless from any injury that may result from that use.
6.Always wear approved safety glasses/face shields while using the table saw. Everyday eyeglasses only have impact resistant lenses; they are not safety glasses.
7.Before operating the table saw, remove tie, rings, watches and other jewelry, and roll sleeves up past the elbows. Remove all loose clothing and confine long hair.
8.Always use the blade guard on all ''through- sawing'' operations. A
9.Kickback occurs when the workpiece is thrown towards the operator at a high rate of speed. If you do not have a clear understanding of kickback and how it occurs, DO NOT operate the table saw!
10.Wear ear protectors (plugs or muffs) during extended periods of operation.
11.Some dust created by power sanding, sawing, grinding, drilling and other construction activities contain chemicals known to cause cancer, birth defects or other reproductive harm. Some examples of these chemicals are:
•Lead from lead based paint.
•Crystalline silica from bricks, cement and other masonry products.
•Arsenic and chromium from chemically treated lumber.
Your risk of exposure varies, depending on how often you do this type of work. To reduce your exposure to these chemicals, work in a
12.Do not operate this machine while tired or under the influence of drugs, alcohol or any medication.
13.Make certain switch is in OFF position before connecting the machine to the power supply.
14.Make certain the machine is properly grounded.
15.Make all machine adjustments or maintenance with the machine unplugged from the power source.
16.Remove adjusting keys and wrenches. Form a habit of checking to see that keys and adjusting wrenches are removed from the machine before turning it on.
17.Keep safety guards in place at all times when the machine is in use. If removed for maintenance purposes, use extreme caution and replace the guards immediately after completion of maintenance.
18.Check damaged parts. Before further use of the machine, a guard or other part that is damaged should be carefully checked to determine that it will operate properly and perform its intended function. Check for alignment of moving parts, binding of moving parts, breakage of parts, mounting and any other conditions that may affect its operation. A guard or other part that is damaged should be properly repaired or replaced.
19.Provide for adequate space surrounding work area and
20.Keep the floor around the machine clean and free of scrap material, oil and grease.
21.Keep visitors a safe distance from the work area. Keep children away.
22.Make your workshop child proof with padlocks, master switches or by removing starter keys.
23.Give your work undivided attention. Looking around, carrying on a conversation and “horse- play” are careless acts that can result in serious injury.
4