Powermatic 3520A instruction manual Electrical Remote ON/OFF Switch Optional

Page 29

ELECTRICAL: Remote ON/OFF Switch (Optional)

NOTE:

The lathe can only operate when both the headstock and remote switches are in the "ON" position.

STEP 1:

Disconnect all electrical power to lathe.

STEP 2:

Remove the two screws from the control panel.

Do NOT disconnect control panel from wiring harness.

STEP 3:

Run the remote switch's wiring harness through the opening in the back of the headstock and out through the front of the headstock.

STEP 4:

Connect the remote switch wiring harness to the back of the Push/Pull switch (Refer to the electrical schematic on page 29).

STEP 5:

Reinstall the control panel to the headstock.

From the back of the headstock, lightly pull out any excess wire that may be inside the headstock.

STEP 6:

The magnetic back on the remote switch will allow the switch to be placed anywhere on the lathe.

STEP 7:

Connect electrical power to the lathe and resume operation.

29

Image 29
Contents Woodturning Lathe Warranty & Service Table of Contents Securely fasten spur centers to the material being used Safety RulesPage Safety Decals Specifications 3520A Lathe Adjustments Receiving InstallationMaintenance Tool Support Speed Range AdjustmentSpindle Diameter of Work Roughing RPM General Cutting Finishing RPMOperating Instructions ToolsMounting Stock Spindle TurningStock Selection Beads Cutting Techniques Roughing OUTCoves CutsParting OFF Face Plate & Bowl TurningWood Selection Faceplate or CHUCK?Tools for Bowl Turning To Shape Outside of BowlTo Shape Interior of Bowl Sanding and Finishing Problem Possible Cause Solution TROUBLE-SHOOTING 3520A LatheDescription Quantity Parts List Headstock Assembly 3520A Lathe6821492 Headstock Assembly 3520A Lathe Parts List Stand & Bed Assembly 3520A Lathe Stand & Bed Assembly 3520A Lathe Optional Accessories Indexer & Bed Extensions 3520A Lathe Optional Accessories Indexer & Bed Extensions 3520A Lathe No. Part No. Description Optional Accessories Tool Supports 3520A LatheOptional Accessory Outboard Turning Stand 3520A Lathe Optional Accessory Optional Accessories 3520A LatheOptional Accessories Part No. DescriptionElectrical Schematic 3520A Lathe Electrical Remote ON/OFF Switch Optional Electrical Schematic 3520A Lathe with Remote Switch Optional Electrical Schematic 3520A School Lathe #1352002 Electrical Schematic 3520A School Lathe 2330009 Kit AC Inverter Readings Lathe Speed Chart Remove indexing pin from indexer before operating lathe Page ALL Rights Reserved