2.Lightly mark the center of the "V" with the tip of the skew.
3.Move the point of the skew to the right half of the desired width of your cut.
4.With the bevel parallel to the right side of the cut, raise the handle and push the tool in to the desired depth, as shown in Figure 8.
5.Repeat from the left side. The two cuts should meet at the bottom and leave a clean "V" cut.
6.Additional cuts may be taken to add to either the depth or width of the cut.
PARTING OFF:
1.Use parting tool.
2.Adjust lathe speed to lower RPM for parting through a workpiece.
3.Place tool on tool support and raise the handle until it starts to cut and continue to cut towards the center of the workpiece.
4.Loosely hold on to the piece in one hand as it separates from the waste wood.
SANDING & FINISHING: Leaving clean cuts will reduce the amount of sanding required. Adjust the lathe to a low speed, and begin with fine sandpaper (120 grit or finer). Coarser sandpaper will leave deep scratches that are difficult to remove, and dull crisp details on the spindle. Progress through each grit
without skipping grits (e.g., do not jump from 120 grit to 220 grit). Fold the sandpaper into a pad; do not wrap sandpaper around your fingers or the workpiece.
To apply a finish, the workpiece can be left on the lathe. Turn off the lathe and use a brush or paper towel to apply the finish. Remove excess finish before restarting lathe. Allow to dry and sand again with 320 or 400 grit sandpaper. Apply second coat of finish and buff.
FACE PLATE & BOWL TURNING
Face plate turning is normally done on the inboard side of the headstock over the bed. Larger workpieces must be turned on the outboard side (remove tailstock and tool support, and move headstock to opposite end of bed).
MOUNTING STOCK
Use of a face plate is the most common method for holding a block of wood for turning bowls and plates:
1.Select stock at least 1/8" to 1/4" larger than each dimension on the finished workpiece.
2.Always select the largest diameter face plate that can be
used for the workpiece to be turned.
3.True one surface of the workpiece for mounting against the face plate.
4.Using the face plate as a template, mark the location of the mounting holes, and drill pilot holes of the appropriate size. Face plates are drilled for No. 12 screws. (Phillips and square drive screws will hold up better than slotted screws. Sheel metal screws are
case hardened with deeper and sharper threads than wood screws.)
If the mounting screws on the face plate interfere with the workpiece, a glue or waste block can be used:
13