ASSEMBLING GPE ON/OFF SWITCH
1.Locate the GPE switch and hardware that was removed in the section “ASSEMBLING EXTENSION
WING.”
2.Loosely assemble switch and switch bracket (A) Fig. 12, to the inside front lip of extension wing. Insert a 5/16- 18x1" flat head screw (D) through hole (G), place a 5/16" flat washer (E) on screw and secure with a 5/16" hex nut
(F).
3.Attach the side of switch bracket (A) Fig. 13, to the inside of extension wing at the front of the saw using the
E
F 
D G
A
Fig. 12
D
C
A
Fig. 13
ASSEMBLING BLADE GUARD AND SPLITTER ASSEMBLY
DISCONNECT MACHINE FROM POWER SOURCE.
1.Remove the table insert Fig. 14. Raise the saw arbor, by turning the locking
handle on the front of the saw, counter clockwise and then turn the wheel on the front of the saw clockwise as far as it will go, and remove the saw blade from the machine by following the instructions in section
“CHANGING THE SAW BLADE”.
2.The inside splitter mounting bracket (A) Fig. 15, is assembled to the inside of the saw and aligned with the inside blade flange (B) at the factory.
3.To check the alignment, remove screw and fastener plate (C) Fig. 15. Using a straight edge (D) Fig. 16, check to see if the splitter bracket (A) is aligned with the inside blade flange (B). Check both the top and bottom of bracket (A) with the top and bottom of flange (B).
Fig. 14
C
A
B
Fig. 15
12