Delta 36-953 Assembling LVC Starter BOX to Cabinet, Assembling LVC ON/OFF Switch, Wing

Page 11

ASSEMBLING LVC STARTER BOX TO CABINET

If you purchased the machine with magnetic push button electrical controls, the saw is shipped with the starter box completely wired to the switch and motor. However, the starter box must be mounted to the saw cabinet. To assemble the starter box (A) Fig. 7, to the saw cabinet, proceed as follows:

1.Place a 1/4" lockwasher then a 1/4" flat washer onto a 1/4-20x1/2" hex head screw. From the inside rear of the saw cabinet, insert the 1/4-20 x 1/2" hex head screw into the hole (B) Fig. 7, in the cabinet. Repeat this process for the two remaining screws.

2.Line up the three tapped holes (C) Fig. 7, in the starter box with the screws and secure the starter box (A), to the saw cabinet.

3.Figure 8 illustrates the starter box (A) assembled to the saw cabinet.

A

B

C

Fig. 7

A

Fig. 8

ASSEMBLING LVC ON/OFF SWITCH

1.Locate the LVC switch and hardware that was removed in the section “ASSEMBLING EXTENSION

WING.”

2.Mount the switch bracket (C) Fig. 9, to the inside of through hole D) on the left front edge of the extension wing with the hardware that was removed.

NOTE: If you have a GPE switch see “ASSEMBLING GPE ON/OFF Switch” instructions.

D

C

A

Fig. 9

11

Image 11
Contents Unisaw 10 Left Tilting Arbor Saw Important Safety Instructions Table of ContentsCalifornia Proposition Safety Guidelines DefinitionsUSE of this Tool can Generate General Safety RulesImportant Safety Instructions Stay ALERT, Watch What YOU are DOING,Failure to Follow These Rules MAY Result in Serious Injury Additional Safety Rules for Table SawsALL CASES, Make Certain Power ConnectionsMotor Specifications Grounding InstructionsPermanently connected machines Extension CordsFunctional Description Carton ContentsAssembly Tools Required AssemblyUnpacking and Cleaning Assembling Extension Wing Wing Assembling LVC ON/OFF SwitchAssembling LVC Starter BOX to Cabinet Disconnect Machine from Power Source Assembling GPE ON/OFF SwitchAssembling Blade Guard and Splitter Assembly Page Page Shows the motor cover attached to the Unisaw Attaching Motor CoverAssembling Dust Chute Adapter Miter Gage Holder Wrench HolderAssembling RIP Fence Holder Brackets Operation Adjusting Table Adjusting 90 and 45 Degree Positive StopsMiter Gage Operation Adjustment Adjusting Table InsertChanging the Blade Replacing Belts and Adjusting Belt TensionCROSS-CUTTING Never USE the Fence AS a CUT-OFF Gage When CROSS-CUTTINGCommon Sawing Operations Ripping Using Unifence AS CUT-OFF Gage61A. Note Guard Removed for Clarity Always USE the Guard Using Auxiliary Wood Facing on Biesemeyer RIP FenceUsing Auxiliary Wood Facing on the Unifence Constructing a Push StickAccessory Moulding Cutterhead Accessory Dado Head Constructing a Featherboard Constructing a Push Stick PushstickService Troubleshooting MaintenanceAccessories Two Year Limited New Product Warranty WarrantyPage Canadian PORTER-CABLE Delta Service Centers