Delta 36-953 instruction manual

A

BD

Fig. 16

4.If an adjustment is necessary, loosen two screws (F) Fig. 17, and adjust splitter bracket (A) until it is aligned with the inside blade flange (B) Fig. 15. Tighten two screws (F). Loosely assemble screw and fastener plate (C), which were removed in STEP 2.

5.Insert threaded end of support rod (G) Fig. 18, through slot in rear of saw and into hole in rear trunnion

(H). Fasten support rod (G) to trunnion with star washer and 5/8-18 hex jam nut (J) Fig. 19. NOTE: Thread nut (J) Fig. 19, onto threads of support rod (G) as much as possible by hand.

6.Using a wrench to hold the 5/8-18 hex jam nut (J) Fig. 19, tighten rod (G) Fig. 20, with a small screwdriver (K) or similar device through the hole in the end of the rod as shown in Figure 20.

7.Assemble lower bracket (L) Fig. 21, to rod (G) and loosely tighten with two 5/16-18x1" hex head screws (S) and 5/16" lockwashers (T) from underneath bracket (L).

8.Align the hole in the upper splitter bracket (M) Fig. 22, with the hole in the lower splitter bracket (L). Place a

K

G

Fig. 20

A

F

Fig. 17

G

H

Fig. 18

J

Fig. 19

L

T

T

S

G

Fig. 21

13