Delta 36-312 instruction manual Two Year Limited New Product Warranty

Page 16

Two Year Limited New Product Warranty

Delta will repair or replace, at its expense and at its option, any new Delta machine, machine part, or machine accessory which in normal use has proven to be defective in workmanship or material, provided that the customer returns the product prepaid to a Delta factory service center or authorized service station with proof of purchase of the product within two years and provides Delta with reasonable opportunity to verify the alleged defect by inspection. For all refurbished Delta product, the warranty period is 180 days. Delta may require that electric motors be returned prepaid to a motor manufacturer’s authorized station for inspection and repair or replacement. Delta will not be responsible for any asserted defect which has resulted from normal wear, misuse, abuse or repair or alteration made or specifically authorized by anyone other than an authorized Delta service facility or representative. Under no circumstances will Delta be liable for incidental or consequential damages resulting from defective products. This warranty is Delta’s sole warranty and sets forth the customer’s exclusive remedy, with respect to defective products; all other warranties, express or implied, whether of merchantability, fitness for purpose, or otherwise, are expressly disclaimed by Delta.

16

Image 16
Contents Single-Bevel Compound Miter Saw General Safety Rules Safety Guidelines DefinitionsImportant Safety Instructions Failure to Follow These Rules MAY Result in Serious Injury Stay ALERT, Watch What YOU are DoingAdditional Safety Rules for Miter Saws Power Connections Motor SpecificationsExtension Cords UnpackingAttaching Dust BAG ForewordMoving Cuttinghead to the UP Position Moving Table to the 0 CUT-OFF Position Fence OperationFastening Machine to Supporting Surface ED ELocking Switch in the OFF Position Constructing Work Support ExtensionsStarting and Stopping Machine Rotating Table for Miter CuttingAdjusting Sliding FIT Between Movable Table and Base Adjusting Fence 90 to BladeDisconnect the Machine from the Power Source Table Hazard ZoneAdjusting 0, 33.9, and 45 Bevel Positive Stops Disconnect Machine from Power SourceTilting Cuttinghead for Bevel Cutting Selecting 0, 33.9, and 45 Bevel Positive StopsAdjusting the Bevel Lock Adjusting Sliding FIT Between Trunnion and Bevel BracketAdjusting the Tension of Cuttinghead Return Spring Adjusting Sliding FIT Between Cuttinghead ARM and TrunnionAdjusting Lower Blade Guard Typical Operations and Helpful HintsAuxiliary Wood Fence Cutting Aluminum Cutting Bowed Material Cutting Crown MouldingMaintenance Keep Tool CleanFailure to Start Changing the BladeAccessories Brush Inspection and ReplacementTwo Year Limited New Product Warranty Canadian PORTER-CABLE Delta Service Centers Arizona Illinois Minnesota