Delta 28-348 instruction manual Stand Door to Stand, Dust Port

Page 11

BAND SAW USED WITH A DUST

COLLECTOR

3.If you are going to use your band saw with a dust collector, attach the dust port as follows:

A.Align the four holes in the dust port (A) Fig. 15, with the four holes in the side of the stand.

B.NOTE: THE DUST CHUTE WILL ONLY BE ATTACHED AT THE TWO BOTTOM HOLES

(C) IN THE DUST PORT.

C.Insert #10-32x1/2" pan head screws through the four holes (B) and (C) Fig. 15, in the dust port, and cabinet. Thread #10-32 hex nuts onto the screws, and tighten securely.

BAND SAW USED WITHOUT A

DUST COLLECTOR

3.If you are not going to use a dust collector with your band saw proceed as follows:

Insert #10-32x1/2" pan head screws through holes (A) Fig. 16, in the cabinet and dust chute. Thread #10-32 hex nuts onto the screws, and tighten securely.

STAND DOOR TO STAND

1.Align the two holes in the hinge pins (A) Figs. 17 and 18, with the two holes on the cabinet. NOTE: MAKE

SURE THE HINGE PINS (A) ARE POINTED UP AS SHOWN IN FIGS. 17 AND 18.

2.Insert #10-24x1/2" socket head cap screws through the holes in the cabinet, (from the inside of the stand), and thread the screw into the hinge pins.

NOTE: DO NOT COMPLETELY TIGHTEN THE SCREWS AT THIS TIME.

3.Make sure the two hinge pins (A) are aligned with each other by using a straight edge as shown in Fig18.

4.Tighten the four screws securely.

BB

A

CC

Fig. 15

A

Fig. 16

A

Fig. 17

A

Fig. 18

11

Image 11
Contents Metal/Wood Cutting Band Saw Important Safety Instructions Safety Guidelines DefinitionsStay ALERT, Watch What YOU are DOING, Additional Safety Rules For Band Saws Power Connections Functional Description Unpacking and Cleaning Band SAW Parts Motor to Motor Bracket AssemblyMotor Bracket To Cabinet Dust Chute TOP Plate to CabinetDust Port Sure the Hinge Pins a are Pointed UP AS Shown in FigsStand Door to Stand Tighten the Screws AT this Time Hinge Opening is Pointing DownBelt to SAW and Motor Pulley Disconnect Machine from Power SourceSAW to Stand Motor PulleyAre Positioned AS Shown in FIG Table to SAWLength Blades Blade to SAWTable Insert On / OFF Switch To Stand Tilting the Table Operating Controls and AdjustmentsLocking Switch in the OFF Position Starting Stopping SAWTo adjust the 90 degree stop Adjusting Table StopsAdjusting Blade Tension Never Track the Blade While Tool is Running Tracking the BladeChanging Speeds Adjusting Lower Blade Guides and Blade Support BearingCD C OperationsCutting Curves Troubleshooting GuideTrouble Band SAW does not Come UP to Speed Suggested Metal Cutting Blades and Speeds Band SAW BladesLubrication MaintenanceChanging the Blades PARTS, Service or Warranty Assistance AccessoriesCanadian PORTER-CABLE Delta Service Centers