Delta 28-348 Operating Controls and Adjustments, Starting Stopping SAW, Tilting the Table

Page 17

OPERATING CONTROLS AND ADJUSTMENTS

STARTING AND

STOPPING SAW

The power switch is located on the left side of the machine. To turn the machine “ON”, push the green start button (A) Fig. 41. To turn the machine “OFF”, push the red stop button (B).

A

B

Fig. 41

LOCKING SWITCH IN THE “OFF” POSITION

IMPORTANT: When the tool is not in use, the switch should be locked in the “OFF” position to prevent unauthorized use, using a padlock (C) Fig. 42 with a 3/16" diameter shackle.

TILTING THE TABLE

1. DISCONNECT MACHINE FROM POWER SOURCE.

2.The table on the band saw can be tilted 45 degrees to the right and 9 degrees to the left. To tilt the table to the right, loosen the two clamp handles (A) Fig. 43, tilt the table to the desired angle as shown on the scale (D) Figs. 43 and 44, and tighten two locking handles (A) Fig.

3.To tilt the table to the left, loosen the two locking handles (A) Fig. 43, and tilt the table to the right until the table stops (B) Fig. 44 can be accessed. Rotate the table stop (B) Fig. 44, and tilt the table to the left. Tighten the two locking handles (A) Fig. 43.

C

Fig. 42

D

A

A

Fig. 43

B

D

Fig. 44

17

Image 17
Contents Metal/Wood Cutting Band Saw Important Safety Instructions Safety Guidelines DefinitionsStay ALERT, Watch What YOU are DOING, Additional Safety Rules For Band Saws Power Connections Functional Description Unpacking and Cleaning Band SAW Parts Motor to Motor Bracket AssemblyMotor Bracket To Cabinet Dust Chute TOP Plate to CabinetDust Port Sure the Hinge Pins a are Pointed UP AS Shown in FigsStand Door to Stand Tighten the Screws AT this Time Hinge Opening is Pointing DownSAW to Stand Disconnect Machine from Power SourceMotor Pulley Belt to SAW and Motor PulleyAre Positioned AS Shown in FIG Table to SAWLength Blades Blade to SAWTable Insert On / OFF Switch To Stand Locking Switch in the OFF Position Operating Controls and AdjustmentsStarting Stopping SAW Tilting the TableTo adjust the 90 degree stop Adjusting Table StopsAdjusting Blade Tension Never Track the Blade While Tool is Running Tracking the BladeChanging Speeds Adjusting Lower Blade Guides and Blade Support BearingCD C OperationsCutting Curves Troubleshooting GuideTrouble Band SAW does not Come UP to Speed Suggested Metal Cutting Blades and Speeds Band SAW BladesLubrication MaintenanceChanging the Blades PARTS, Service or Warranty Assistance AccessoriesCanadian PORTER-CABLE Delta Service Centers