Delta 34-814 Attaching the LVC Starter BOX to the Cabinet, Attaching the LVC ON/OFF Switch, Wing

422-04-651-0064 - 06-20-05.qxd 6/20/05 1:42 PM Page 9

Use a straight edge (C) Fig. 6 to be sure that the extension wing (A) and the saw table (D) are even with each other before tightening the screws (B) Fig. 5.

C

A

D

Fig. 6

ATTACHING THE LVC STARTER BOX TO THE CABINET

If your saw has magnetic push button electrical controls, the starter box is already wired to the switch and motor. However, you will need to mount the starter box to the saw cabinet.

1.Place a 1/4" lockwasher, then a 1/4" flat washer on a 1/4-20x1/2" hex head bolt. Insert the bolt through one of the holes (B) Fig. 7 on the inside of the saw cabinet and into the matching tapped hole (C) Fig. 7 in the starter.Tighten just enough to hold the starter.

2.Repeat for the remaining 2 holes.

3.Tighten all three bolts securely.

Fig. 7

C

A

B

ATTACHING THE LVC ON/OFF SWITCH

1.Locate the LVC switch (A) Fig. 8 and the hardware that was removed in the section “ATTACHING THE EXTENSION

WING.”

2.Use the hardware to mount the switch bracket (C) Fig. 9 to the inside of the table through the hole (D) on the left front edge of the extension wing.

NOTE: If you have a GPE switch see “ATTACHING THE GPE ON/OFF Switch” instructions.

D

A

c

Fig. 8 Fig. 9

9