Delta 34-806, 34-814, 34-801 Fastening the Motor Cord to the SAW Frame, Attaching Motor Cover

422-04-651-0064 - 06-20-05.qxd 6/20/05 1:43 PM Page 13

12.Use a straight edge (A) Fig. 25 to make certain that the splitter (P) is aligned with the saw blade (B). Use a square (C) Figs. 27 and 28 to make certain that the saw blade (B) Fig. 26 and splitter (P) Fig. 27 are 90° to the table surface. Tighten all splitter mounting hardware (D) Fig. 27 and re-check the alignment.

13.Hold the clear blade guard (X) Fig. and lower the saw blade. Attach the table insert (E) Fig. 30 into the opening on the saw table.

P

C

D

Fig. 27

C

B

Fig. 26

E

Fig. 28

FASTENING THE MOTOR CORD TO THE SAW FRAME

1.Raise the saw arbor by turning the height adjusting handle on the front of the saw counter-clockwise as far as it will go. Then turn the angle adjusting handle on the front of the saw clockwise as far as it will go.

2.Fasten motor cord (A) Fig. 29 to the saw frame cross member (B), using the cable tie (C) supplied with the saw.

CAUTION: Before tightening the cable tie, make certain that the electrical cord (A) is free of any interference from the motor or saw blade in all positions.

3.After the cable tie is tightened, cut off the excess tail

(C) Fig. 29.

ATTACHING MOTOR COVER

A

B

C

Fig. 29

NOTE: If you have an “LVC” (Starter Box) version Unisaw, you will have to attach two bottom spring clips to the motor cover. The spring clips come attached to the “GPE version Unisaw.

1.Attach the two motor cover clips to the motor cover. Align the hole in the motor cover clip with the hole in the motor cover. Place a 13/64 flat washer on a 10-32 x 1/2" screw (A) Fig. 30. Insert the screw through the hole in the motor cover clip and thread the screw (A) into the tapped hole in the motor cover.

A

Fig. 30

13