Echo PAS-225SB specifications Handling Fuel, After use

Page 16

OPERATION

PAS-225SB

 

 

Two Stroke Oil - A two-stroke engine oil meeting ISO-L-EGD (ISO/CD 13738) and J.A.S.O. FD Standards must be used. Echo brand premium Power Blend XUniversal 2-Stroke Oil meets these standards. Engine problems due to inadequate lubrication caused by failure to use an ISO-L-EGD (ISO/CD 13738) and J.A.S.O. FD certified oil, such as Echo premium Power Blend X, will void the two-stroke engine warranty.

Echo premium Power Blend XUniversal 2-Stroke Oil may be mixed at 50:1 ratio for application in all Echo engines sold in the past regardless of ratio specified in those manuals.

Handling Fuel

Fuel is VERY flammable. Use extreme care when mixing, storing or handling, or serious personal injury may result.

Use an approved fuel container.

DO NOT smoke near fuel.

DO NOT allow flames or sparks near fuel.

Fuel tanks/cans may be under pressure. Always loosen fuel caps slowly allowing pressure to equalize.

NEVER refuel a unit when the engine is HOT or RUNNING!

DO NOT fill fuel tanks indoors. ALWAYS fill fuel tanks outdoors over bare ground.

DO NOT overfill fuel tank. Wipe up spills immediately.

Securely tighten fuel tank cap and close fuel container after refueling.

Inspect for fuel leakage. If fuel leakage is found, do not start or operate unit until leakage is repaired.

Move at least 3m (10 ft.) from refueling location before starting the engine.

Mixing Instructions

1.Fill an approved fuel container with half of the required amount of gasoline.

2.Add the proper amount of 2-stroke oil to gasoline.

3.Close container and shake to mix oil with gasoline.

4.Add remaining gasoline, close fuel container, and remix.

Spilled fuel is a leading cause of hydrocarbon emissions. Some states may require the use of automatic fuel shut-off containers to reduce fuel spillage.

After use

DO NOT store a unit with fuel in its tank. Leaks can occur. Return unused fuel to an approved fuel storage container.

For more information scan this QR code.

16

 

 

X7722277602

 

 

 

 

 

© 02/2014 ECHO Inc.

Image 16
Contents Operator’s Manual Burn HazardTable of Contents Introduction Servicing InformationAdditional or Replacement Manuals SafetyManual Safety Symbols and Important Information International Symbols PAS-225SBPersonal Condition and Safety Equipment Vibration and Cold Repetitive Stress InjuriesEquipment EPA 2010 and Later and/or C.A.R.B. Tier Emission Control Exhaust & EvaporativeProduct Emission Durability Emission Compliance Period Description Description Contents Power Head Shaft/Lower Shaft Assembly AssemblyPlastic Shield Installation To Advance Trimmer Line Nylon Line Head InstallationRemove Nylon Line Head Support Handle Installation OperationFuel Fuel RequirementsHandling Fuel After useOperation With Blades Blade SelectionOperation Starting Cold Engine Purge BulbStarting Warm Engine Stopping EngineMaintenance Intervals MaintenanceSkill Levels Air Filter Fuel FilterSpark Plug Cooling SystemExhaust System Spark Arrestor ScreenCarburetor Adjustment Exhaust Port CleaningEngine Break-In High Altitude OperationLubrication Gear HousingDrive Shaft lower Nylon Line Head Disassembly Instructions Drive Shaft UpperNylon Line Replacement Trimmer head is now fully loaded and ready for operationSharpening Metal Blades Troubleshooting Engine Problem Troubleshooting ChartStorage Storage Hook InstallationLong Term Storage Over 30 Days Specifications ModelEcho Approved Optional Attachments Recommended Optional AttachmentsWarranty Statement OWNER’S ResponsibilityWarranty Statement ECHO, Incorporated