Echo PAS-225SB specifications Storage Hook Installation, Long Term Storage Over 30 Days

Page 31

PAS-225SB

STORAGE

 

 

STORAGE

Storage Hook Installation

1.Insert small end of hook into locating hole on attachment shaft.

2.Slide plastic cap onto end of attachment shaft.

Long Term Storage (Over 30 Days)

During operation the muffler or catalytic muffler and surrounding cover become hot. Always keep exhaust area clear of flammable debris during transportation or when storing, otherwise serious property damage or personal injury may result.

Do not store your unit for a prolonged period of time (30 days or longer) without performing protective storage maintenance which includes the following:

1. Store unit in a dry, dust free place, out of the reach of children.

Do not store in enclosure where fuel fumes may accumulate or reach an open flame or spark.

2.Place the stop switch in the “OFF” position.

3.Remove accumulation of grease, oil, dirt and debris from exterior of unit.

4.Perform all periodic lubrication and services that are required.

5.Tighten all the screws and nuts.

6.Drain fuel tank completely. Press purge bulb 6 -7 times to remove remaining fuel from carburetor then drain the tank again. Close choke, start and run the engine until it stops due to lack of fuel.

7.

a.Allow engine to cool then remove the spark plug and pour 7 cc (1/4 oz.) of fresh, clean, two-stroke engine oil into the cylinder through the spark plug hole.

b.Pull the recoil starter handle 2-3 times to distribute the oil inside the engine.

c.Observe the piston location through the spark plug hole. Pull the recoil handle slowly until the piston reaches the top of its travel and leave it there.

8.Install the spark plug (do not connect ignition cable).

X7722277602

31

© 02/2014 ECHO Inc.

Page 30 Page 32
Image 31
Page 30 Page 32
Contents Burn Hazard Operator’s ManualTable of Contents Servicing Information IntroductionAdditional or Replacement Manuals SafetyManual Safety Symbols and Important Information PAS-225SB International SymbolsPersonal Condition and Safety Equipment Repetitive Stress Injuries Vibration and ColdEquipment EPA 2010 and Later and/or C.A.R.B. Tier Emission Control Exhaust & EvaporativeProduct Emission Durability Emission Compliance Period Description Description Contents Power Head Shaft/Lower Shaft Assembly AssemblyPlastic Shield Installation To Advance Trimmer Line Nylon Line Head InstallationRemove Nylon Line Head Fuel Requirements Support Handle InstallationOperation FuelAfter use Handling FuelBlade Selection Operation With BladesOperation Purge Bulb Starting Cold EngineStopping Engine Starting Warm EngineMaintenance Intervals MaintenanceSkill Levels Fuel Filter Air FilterCooling System Spark PlugSpark Arrestor Screen Exhaust SystemHigh Altitude Operation Carburetor AdjustmentExhaust Port Cleaning Engine Break-InLubrication Gear HousingDrive Shaft lower Drive Shaft Upper Nylon Line Head Disassembly Instructions Trimmer head is now fully loaded and ready for operation Nylon Line ReplacementSharpening Metal Blades Engine Problem Troubleshooting Chart TroubleshootingStorage Storage Hook InstallationLong Term Storage Over 30 Days Model SpecificationsRecommended Optional Attachments Echo Approved Optional AttachmentsOWNER’S Responsibility Warranty StatementWarranty Statement ECHO, Incorporated
Top Page Image Contents