Echo PAS-225SB specifications Equipment

Page 8

SAFETY

PAS-225SB

 

 

 

 

 

 

All over head electrical conductors and communications wires can have electricity flow with high voltages. This unit is not insulated against electrical current. Never touch wires directly or indirectly, otherwise serious injury or death may result.

Do not operate this product indoors or in inadequately ventilated areas. Engine exhaust contains poisonous emissions and can cause serious injury or death.

Read the Manuals

Provide all users of this equipment with the Operator’s Manual and Safety Manual for instructions on Safe Operation.

Clear the Work Area

Spectators and fellow workers must be warned, and children and animals prevented from coming nearer than 15 m (50 ft.) while the unit is in use.

Keep a Firm Grip

Always hold throttle handle and support handle with thumbs and fingers tightly encircling the handles.

Keep a Solid Stance

Maintain footing and balance at all times. Do not stand on slippery, uneven or unstable surfaces. Do not work in odd positions or on ladders. Do not over reach.

Avoid Hot Surfaces

During operation, the drive shaft housing and attachment bearing housing may become very hot, too hot to touch. Avoid

contact during and immediately after operation.

Equipment

Use only ECHO approved attachments. Serious injury may result from the use of a non-approved attachment combination. ECHO, INC. will not be responsible for the failure of cutting devices, attachments or accessories which have not been tested and approved by ECHO. Read and comply with all safety instructions listed in this manual and safety manual.

Check unit for loose/missing nuts, bolts, and screws. Tighten and/or replace as needed.

Inspect guards and shields for damage and to ensure that they are securely in place. Replace if damaged or missing.

Check that the attachment is firmly attached and in safe operating condition.

Check that handle and harness (if included) are adjusted for safe, comfortable operation. See Assembly Section for proper adjustment.

8

 

 

X7722277602

 

 

 

 

 

© 02/2014 ECHO Inc.

Image 8
Contents Operator’s Manual Burn HazardTable of Contents Introduction Servicing InformationManual Safety Symbols and Important Information SafetyAdditional or Replacement Manuals International Symbols PAS-225SBPersonal Condition and Safety Equipment Vibration and Cold Repetitive Stress InjuriesEquipment Product Emission Durability Emission Compliance Period Emission Control Exhaust & EvaporativeEPA 2010 and Later and/or C.A.R.B. Tier Description Description Contents Plastic Shield Installation AssemblyPower Head Shaft/Lower Shaft Assembly Remove Nylon Line Head Nylon Line Head InstallationTo Advance Trimmer Line Support Handle Installation OperationFuel Fuel RequirementsHandling Fuel After useOperation With Blades Blade SelectionOperation Starting Cold Engine Purge BulbStarting Warm Engine Stopping EngineSkill Levels MaintenanceMaintenance Intervals Air Filter Fuel FilterSpark Plug Cooling SystemExhaust System Spark Arrestor ScreenCarburetor Adjustment Exhaust Port CleaningEngine Break-In High Altitude OperationDrive Shaft lower Gear HousingLubrication Nylon Line Head Disassembly Instructions Drive Shaft UpperNylon Line Replacement Trimmer head is now fully loaded and ready for operationSharpening Metal Blades Troubleshooting Engine Problem Troubleshooting ChartLong Term Storage Over 30 Days Storage Hook InstallationStorage Specifications ModelEcho Approved Optional Attachments Recommended Optional AttachmentsWarranty Statement OWNER’S ResponsibilityWarranty Statement ECHO, Incorporated