Bush Hog FC-BL-0002 manual Hydraulic System, Selector Valve Accessory Equipment

Page 30

ASSEMBLY

ASSEMBLY

Hydraulic System

The Hydraulic Cylinders are designed to be used in conjunction with your tractor's Hydraulic System. The Cylinders and Hose are designed for maximum system pressure of 2500 PSI.

Keep Cylinders and Hoses free from internal contamination. Never leave a disconnected Hose end open. Use a Sealant when attaching Hydraulic Hose to Cylinder. Do not over tighten fittings as this will break out the Cylinder Port Housings. Do not operate with hydraulic oil leaking. Oil is expensive and its presence could cause slips and falls and other hazards. DO NOT CHECK FOR LEAKS WITH YOUR HAND. USE CARDBOARD INSTEAD. High-pressure oil can penetrate the skin and cause tissue damage or even GANGRENE. If oil does penetrate the skin, have it REMOVED IMMEDIATELY by a surgeon skilled in this procedure.

NOTE: Never rotate Blade Tilt, Carrier Pivot, or Mainframe Pivot with hydraulics while Blade is under load. This will cause excessive load on pins and shafts which will result in damage to Blade. Remove load from Blade and then rotate.

Selector Valve (Accessory Equipment)

If the Mainframe Swing, Moldboard Pivot and Tilt are fully hydraulic, as an added feature, all three Cylinders can be operated from two remote outlets. Below is a schematic diagram showing proper routing of two Cylinders through the Selector Valve. When installing this Valve, observe all safety precautions as hydraulic lines are under high pressure (2500 PSI). If additional information is required concerning your hydraulic system, contact your Bush Hog dealer. (Figure Asm-0008).

100 Series 08/10

Assembly Section 3-6

© 2010 Alamo Group Inc.

Page 29 Page 31
Image 30
Page 29 Page 31
Contents Series Warranty Information To the Owner/Operator/DealerTable of Contents Page Safety Section Safety Safety MessagesSeries 08/10 Safety Section Safety Safety Safety S3PT-02 Parts Information See Your Bush HOG DealerDecal Location Instruct PeligroReflect LogoDecal Description Safety Logo Product Name Safety Federal Laws and Regulations Page Introduction Section Introduction Introduction Before Operating this Machine Assembly Section Assembly Planer Wheel Operation Special NoticeFigure Asm-0003or optional Manual Adjusting Links Gauge Wheel Extra Equipment Skid Shoes & Quick Tack End Plates Extra EquipmentSelector Valve Accessory Equipment Hydraulic SystemHydraulic Control Valve Accessory Equipment Page Operation Section Operation Operation CAT I-II, QHOperator Requirements Personal Protective Equipment PPETractor Horsepower Tractor RequirementsRops and Seat Belt Front End Weight Getting on and OFF the TractorTractor 3-Point Hitch Boarding the Tractor Dismounting the TractorConnecting the Rear Blade to the Tractor Starting the TractorConnecting the Rear Blade PRE-OPERATION Inspection and Service Tractor Pre-Operation Inspection/ServiceBlade Pre-Operation Inspection/Service Do not Operate an Unsafe Tractor or Implement Blade & Box Blade PRE-OPERATION Inspection Driving the Tractor and Implement Brake and Differential Lock Setting Starting the TractorOperating the Tractor and Implement Driving the Tractor and BladeOperating the Blade Disconnecting the Blade from the Tractor Shutting Down the ImplementBlade Storage Transporting the Tractor and Implement Transporting on Public RoadwaysOperation Hauling the Tractor and Implement Operation Troubleshooting Guide Problem Possible Cause RemedyOperation Maintenance Section Maintenance Proper Torque For Fasteners Bush HOG Required of the Owner Required of the OperatorSeries Rear Mounted Blade
Top Page Image Contents