Fig. 1
4.The Handle (B13) must be installed onto the Holder (B09) using the two supplied Hex Screws (B12). (See Fig. 1.)
Holding Clips
Fig. 2
5.Be sure the water pump (A25) is properly installed within its holding clips (see Fig. 2). Run the water hose from the pump discharge to the Blade Cover (A30) and plug the pump power cable into an outlet. The water from the pump can now keep the blade wet for proper cooling.
Mounting
This tool can be placed on a table or other stable surface. The ideal method would be to mount the tile saw on the stand made for it, SKU 98328 (not in- cluded, sold separately).
OPERATING INSTRUCTIONS
Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the beginning of this manual including all text under subheadings therein before set up or use of this product.
Work Piece and Work Area Set Up
1.Designate a work area that is clean and
2.Route the power cord along a safe route to reach the work area without creating a tripping hazard or exposing the power cord to possible damage. The power cord must reach the work area with enough extra length to allow free move- ment while working.
3.Secure loose work pieces using a vise or clamps (not included) to prevent move- ment while working.
4.There must not be objects, such as utility lines, nearby that will present a hazard while working.
|
| REV 10b |
Page 12 | For technical questions, please call | SKU 98265 |