Chicago Electric 98265 General Operating Instructions, Sliding Bar Support Bevel Scale

Page 13

General Operating Instructions

Power Switch

Reset Button

Fig. 3

1.When making a flat cut, slide the piece to be cut up against the two Fence (D09,D12) halves securely and stabilize one side with the provided Clamp Plate.

2.When making an angled cut, position one end securely at the point where the two Fence halves come together. Use the Clamp Plate to secure it. The cut-off side of the workpiece must be free to move away from the blade to prevent binding.

3.To make a cut, the material to be cut must be placed against the fence and secured by the the Clamp Plate. The sliding unit must be located at the far end of the unit, opposite the Fence and mate- rial to be cut.

4.With the saw and the water pump turned on and operating, pull Handle to move blade through material at a slow and steady pace.

5.Do not attempt to cut on a push stroke, the blade may grab the workpiece.

Knob

Sliding Bar

Support

Bevel Scale

Fig. 4

6.Beveled cuts can also be accomplished by loosening the Knobs (D27) on either side of the saw. Tilt the Sliding Supports, and blade/motor assembly as a unit. There is a scale and indexing pointer on the Sliding Supports indicating angle of tilt. (See Fig. 4.)

7.To prevent accidents, turn off the tool and disconnect its power supply after use. Clean, then store the tool indoors out of children’s reach.

SKU 98265

For technical questions, please call 1-800-444-3353.

Page 13

Image 13
Contents HP 7 Bridge Tile SAW For technical questions or replacement parts, please callSave this Manual General Tool Safety WarningsSave all warnings and instructions for future reference For technical questions, please callNameplate Extension Cord Recommended Minimum Wire Gauge for Extension CordsLength 25’ 50’ 100’ 150’Grounding Instructions Tile Saw Safety Warnings110-120 V~ Grounded Tools Tools With Three Prong Plugs 125 V~ 3-Prong Plug and OutletSafe Method For technical questions, please call Diagram not to scale Essential Straight Push-stick Features FunctionsHandle Notch Stick LengthExtension Cords Position of Tile SAWVibration Safety Save These Structions List of contents SpecificationsAssembly UnpackingOperating Instructions Work Piece and Work Area Set UpMounting Sliding Bar Support Bevel Scale General Operating InstructionsCleaning, Maintenance, Lubrication Maintenance ServicingChanging the Blade Cleaning the Saw TroubleshootingProblem Possible Causes Likely Solutions Part Description Qty Parts List and Assembly Diagram a MotorPart Description Qty Parts List and Assembly Diagram B HangerParts List and Assembly Diagram C Support Part Description Parts List and Assembly Diagram D Work TableParts List and Assembly Diagram E Water Tray Limited 90 DAY Warranty