
CAUTION: Do not use your miter saw with this stand if it cannot be fastened securely to this stand. Refer to the service section of this manual for contact information. Always mount the miter saw as far forward as possible.
14.To remove the miter saw from the stand pull back on the locking levers beneath both mounting supports. (Fig 12)
Note! Prior to assembling your saw to the Miter Saw Stand, unplug the saw, lock the saw head in the down position.
12 |
15. Rotate unit up as shown to clear the beam. (Fig 13)
CAUTION: MITER SAWS CAN BE AWKWARD AND HEAVY. Be sure to have a firm grip and control of the Miter Saw and carefully remove it from the stand. If you need assistance get it.
13 |
16.To replace the saw onto the stand, grasp and lift the saw with the mounting supports attached onto the center beam as shown. Locate the front locks into the front of the beam as shown and then rotate as indicated until the lock clicks in place. (Fig 14)
14 |
17.If adjustment of the saw is necessary, loosen the four bolts and adjust. Ensure that the saw is square with the brackets.
18.Tighten the four nuts holding the saw to the mounting supports securely.
19.Review and understand the operators instruction manual before using the unit.
Carry Handle (Fig 15)
A handle has been supplied to easily transport the Miter Saw Stand to and from the work area.
15 |
8