90539499 01 EM100B.qxd 7/7/08 10:05 AM | Page 14 |
4 . Tu rn the Sensor A rmso that the two Sensor | Sensor LED’s |
LEDs are visible (4). They need to be able to see the |
|
Optical Po rt on the meter. |
|
5 . Push the smaller end of the Sensor Arm upwards through the latch opening and press the Sensor A rm firmly into the cavity (5).
6 . Slide the Sensor A rm as far down as it will go into the bottom cavity of the body. If necessary, use a dull pointed object, such as a ballpoint pen, to push it all the way down (6). The two Sensor LEDs must be visible.
7.Tuck the wire into the side cavity (7).
8. Close the latch (8).
9. Rethread the clamping strap into the sensor housing and reattach the ends. Turn the screw as you feed in the end to reattach it.
03 INSTALLING YOUR METER SENSOR
TYPE 3—ELECTRONIC WITHOPTICAL PORT ON TOP
C. Install Your Meter Sensor
The objective of this step is to align the Sensor
LEDs directly over the optical port on the meter.
1.Stand directly in front of your electric meter, at a height where you can see the optical port . The optical port itself looks like a small
protruding pipe in the center of the top portion of the electric meter. Carefully wipe the meter
dome clean with the damp cloth.
2 . Peel the adhesive backing off of the template. Hold the template with the protruding tab facing you and the arrow pointing away from you .
3 . Stick the template onto the meter with the arrow pointing at, but not cove ring the optical port . You can peel the template off the glass and realign it if necessary.
4 . Align the edges of the sensor with the white side lines on the template. Slide the Meter Sensor over the glass dome as far as it will go.
5 . Tighten the clamp until the Meter Sensor is snug, but can move just enough to allow for adjustments.
6 . Open the Sensor A rm Latch Cover and look down the opening. You’ll see a vertical plastic tab painted white on the inside of the Sensor body.
7.Look through the opening and confi rm that the tip of the white plastic tab on the Sensor is
lined up with the arrow line on the template. Adjust the position of the sensor if necessary.
8 . Press the RESET button . Within 10 seconds, the STATUS indicator will light solid red while the Meter Sensor looks for a signal from the meter. When the Sensor is correctly aligned, the Status indicator will blink .
Status
Reset
Indicator
Button
14 |
|
|
|
| 15 |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|