Installing the Particle Tray
1.Unlock the Table Lock Lever. Lift and turn the
Toggle Table Stop so that its slot aligns with the Table.
2.Pull the Table to the front of the Water Tray Frame.
3.Slide the Particle Tray into the Grooves on the underside of the Table.
4.Return the Table to its working position, and lift then turn the Toggle Table Stop so that its slot aligns sideways.
Figure F: Particle Tray
Grooves
Particle Tray
Table
SAFETY
Water Tray and Pump Setup
1.From the right side of the saw, place the Water Tray (drain plug end to the left) on the lip at the bottom of the Water Tray Frame.
2.Slide the Water Tray in under the Table until it rests in place within the tabs.
3.Adjust the flow control on the Pump to the desired level.
4.Place the Pump into the Pump Bracket in the Pump Basin. It should fit securely into the Bracket.
Water Tray
Frame
Water Tray
Figure G: Water Tray Installation
SETUP
OPERATION
5.Connect the clear water Hose from under the arm of the Motor Head to the Hose Connector on the Pump.
6.Make sure your hands are dry and the Tile Saw is unplugged, then attach the Pump Power Cord to the Pump Outlet on the Motor Head.
7.Fill the Water Tray with clean water up to the Fill Rim (see Figure H) before every use.
Pump
Outlet
Pump | Hose Connector |
Power |
|
Cord |
|
Pump | Drain Plug |
Fill Rim
Pump
Basin
Water
Tray
Figure H: Pump setup
MAINTENANCE
Item 69275 | For technical questions, please call | Page 11 |