SAFETY
Operating Instructions
Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the beginning of this manual including all text under subheadings therein before set up or use of this product.
TOOL SET UP
TO PREVENT SERIOUS INJURY FROM ACCIDENTAL OPERATION:
Turn the Power Switch of the tool to its “OFF” position, remove the key, and unplug the tool from its electrical outlet before assembling or making any adjustments to the tool.
TO PREVENT SERIOUS INJURY:
DO NOT OPERATE WITH ANY GUARD DISABLED, DAMAGED, OR REMOVED.
Installing Blade
SETUP
OPERATION
MAINTENANCE
1.Unplug the saw.
2.Turn the Guard Knob counterclockwise.
3.Open the Guard to expose the Spindle.
4.Loosen the Spindle Nut counterclockwise and remove the old Blade, if installed.
5.Place the Inner Flange onto the Spindle. Install with the cupped side of the Inner Flange facing the tile saw housing.
6.Wipe a drop of oil onto the Inner Flange where it will contact the Blade.
WARNING! TO PREVENT SERIOUS INJURY:
Only use a smooth rim, wet cutting, 10″ Blade rated to at least 3,800 RPM on this tool.
Do not use a Blade that is too thick to allow Outer Flange to engage with the flats on the Spindle.
Do not use a Blade that has openings, grooves, or teeth.
7.Slide the Blade (sold separately) onto Spindle.
8.Place Outer Flange onto the Spindle.
The flats on the Outer Washer align with the flats on the Spindle. Install with the cupped side of the Outer Flange facing the blade.
9.Place Spindle Nut on Spindle.
10.Press and hold the Spindle Lock in.
11.
12.Close the Guard, and use the Guard Knob to secure it.
Inner Outer
Flange Flange
Spindle
Nut
Blade
Figure I: Blade Assembly
Spindle Blade Guard
Lock
Guard
Knob
Wrench
Figure J: Securing Blade
Page 12 | For technical questions, please call | Item 69275 |