THANK YOU for choosing a HARBOR FREIGHT TOOLS product. For future reference, please complete the owner’s record below:
Model______________ | Serial No.____________ | Purchase Date__________ |
SAVE THE RECEIPT, WARRANTY AND THESE INSTRUCTIONS. It is important that you read the entire manual to become familiar with the unit BEFORE you begin assembly.
| Technical Specifications |
Tool Name: | |
SKU: | 41903 |
Cutting Capacity: | |
Motor RPM: | 3,000 RPM |
Arbor Size: | 5/8" |
Safety Switch: | 2 Action |
Blade: | |
Max. Blade RPM: | 7000 |
Also Included: | Quick Charger with U.L. Approved Adapter, 18V Battery, 4 mm Hex Wrench, |
| Blow Mold Case. |
Warning: The warnings, cautions and instructions discussed in this instruction manual cannot cover all possible conditions and situations that may occur. It must be understood by the operator that COMMON SENSE AND CAUTION ARE FACTORS WHICH CANNOT BE BUILT INTO THIS PRODUCT, BUT MUST BE SUPPLIED BY THE OPERATOR.
The Operator
PLEASE REMEMBER:
Do not operate the product if under the influence of alcohol or drugs. Read warning labels on prescriptions to determine if your judgment/reflexes might be impaired.
Do not wear loose clothing or jewelry as they can be caught in moving | WARNING: Some dust created by power | ||
parts. | sanding, sawing, grinding, drilling, and other | ||
Protective gloves and nonskid footwear is recommended. | construction activities, contain chemicals | ||
known [to the State of California] to cause | |||
| |||
Wear restrictive hair covering to contain long hair. | cancer, birth defects or other reproductive | ||
harm. Some examples of these chemicals are: | |||
| |||
Use eye and ear protection. Always wear ANSI approved impact | • | Lead from | |
safety goggles and a dust mask or respirator when working around | • | Crystalline silica from bricks and | |
metal, wood and chemical dusts and mists. |
| cement or other masonry products | |
Wear a full face shield if you are producing metal or wood filings. | • | Arsenic and chromium from | |
| chemically treated lumber | ||
Maintain proper footing and balance at all times. | (California Health & Safety Code 25249.5, et | ||
seq. ) |
| ||
|
| ||
Keep hands out of the cutting area and away from the blade. |
|
| |
Make certain that the piece being cut is properly supported; do not support the piece being cut with your hands or by bracing with your leg.
Avoid carrying the Saw with your fingers on the Handle. Your fingers may touch the Switch and Safety trigger and start the Saw.
REV 02/01; 10/03; 12/04; 02/05
SKU 41903 | For technical questions, please call | Page 2 |