•Whenmakingacutusesteady,evenpressureNever.
forcecuts.
•Donotcutwarpedorwetlumber.
•Alwaysholdyoursawfirmlywithbothhandsandkeep
yourbodyina balancedpositionsoasto resistthe
. forcesofkickbackshoulditoccur.
When using your saw, always stay alert and exercise control. Do not remove your saw from workpiece
while the blade is moving.
DEPTH OF CUT ADJUSTMENT
STARTING A CUT
Know the right way to use your saw.
See Figure 16.
Always keep correct blade depth setting. The correct blade depth setting for all cuts should not exceed 1/4 inch below the material to be cut. More blade depth will increase the chance of kickback and cause the cut to be rough. One blade tooth below the material to be cut works best for most efficient cutting action.
TO ADJUST BLADE DEPTH
•Remove battery pack from saw.
,_ WARNING: Failure to remove battery pack from saw could result in accidental starting causing
possible serious personal injury.
TORAISE
SAW
C |
| TO |
|
| |
TO LOWER |
|
|
SAW |
|
|
|
| DEPTH |
|
| ADJUSTMENT |
|
| KNOB |
BASE | TO |
|
ASSEMBLY |
| |
| LOOSEN | Fig. 15 |
•Loosen depth adjustment knob. See Figure 15.
•Hold base flat against the workpiece and raise or lower saw until the required depth is reached.
•Tighten depth adjustment knob securely.
Fig. 16
Never use your saw as shown in figure 17.
WRONG | Fig. 17 |
Never place your hand on the workpiece behind your
saw while making a cut.
_1, WARNING: To make sawing easier and safer, always maintain proper control of your saw. Loss of
control of your saw could cause an accident resulting in possible serious injury.
15