TO HELP MAINTAIN CONTROL:
•Always support your workpiece near the cut.
•Support your workpiece so the cut will be on your left.
•Clamp your workpiece so it will not move during the cut.
Place your workpiece with its good side down.
Note: The good side is the side on which appearance is important.
Before beginning a cut, draw a guideline along the desired line of cut. Then place front edge of base on that part of your workpiece that is solidily supported. See Figure 16.
Never place your saw on that part of the workpiece that will fall off when the cut is made. See Figure 18
Hold your saw firmly with both hands.
See Figure 19.
RIGHT | Fig. 19 |
Depress the
,_ WARNING: The blade coming in contact with the workpiece before it reaches full speed could cause your saw to "kickback" towards you resulting in serious injury.
When making a cut use steady, even pressure. Forcing
causes rough cuts, could shorten the life of your saw and could cause "kickback."
REMEMBER:
When sawing through work, the lower blade guard
does not cover the blade, exposing it on the
WRONGFig. 18 underside of work, Keep your hands and fingers away from cutting area, Any part of your body coming in contact with the moving blade will result in serious injury.
After you complete your cut release the trigger and allow the blade to come to a complete stop. Do not remove your saw from workpiece while the blade is moving.
,_ CAUTION: When lifting your saw from the workpiece, the blade is exposed on the underside of
your saw until the lower blade guard closes. Make
sure lower blade guard is closed before setting your saw down on work surface.
16