Know Your Trim SAW, Switch, Applications

KNOW YOUR TRIM SAW

See Figure 1.

Before attempting to use your trim saw, familiarize yourself with all operating features and safety requirements.

Features include easily operated bevel cut and depth of cut adjustment mechanisms; positive 0° bevel stop; spindle lock; and blade wrench storage.

_k WARNING: Carefully read through this entire owner's manual before using your new trim saw. Pay

close attention to the Rules For Safe Operation, Warnings and Cautions. If you use your trim saw properly and only for what it is intended, you will enjoy years of safe, reliable service.

Your trim saw has been shipped completely assembled except for the blade. Inspect it carefully to make sure no breakage or damage has occurred during shipping. If any parts are damaged or missing, contact your nearest Sears Retail Store to obtain replacement parts before attempting to operate saw. A blade, blade wrench (5 mm hex key), rip

guide (edge guide) and this owner's manual are also included.

_k WARNING : Do not allow familiarity with your saw to make you careless. Remember that a careless fraction

of a second is sufficient to inflict severe injury.

SWITCH

Your saw is equipped with a lock-off button which reduces the possibility of accidental starting. The lock-off button is located on the handle above the switch trigger. You must depress the lock-off button in order to pull the switch trigger. The lock resets each time the trigger is released. Note: You can depress the lock-off button from either the left or right side.

APPLICATIONS

(Use only for the purposes listed below)

•Cutting all types of wood products (lumber, plywood, paneling).

_ WARNING: If any parts are missing, do not operate your saw until the missing parts are replaced. Failure to

do so could result in possible serious personal injury.

PRODUCT		SPECIFICATIONS:
TRIM SAW				315.271190
Blade	Diameter			6-1/2 in. (165 mm)
Blade	Arbor			3/8 in. (10 mm)
Cutting		Depth	at 90°	2-1/8 in. (54 ram)
Cutting		Depth	at 45 °	1-5/8 in. (42 mm)
No load Speed				2,500 RPM
Motor				18 Volts DC
CHARGER				ITEM NO. _-11040
				(981399-001 )
Input				120 v, 60 Hz, AC only
Charging Voltage				9.6 - 24 Volts
Charge		Rate		1 Hour
BATTERY		PACK		ITEM NO. _-11034
				(981404-001 )