Rev. 0505
6.Slide second case up to first case snugly.Then level second case to the first case so glass front, bumper and top are flush.
7.To compress silicone at joint, use two Jurgenson wood clamps. Make sure case is level from front to back and side to side on inside bulkheads at joint.
8.Attach sections together via a 3 bolts located in the base of the case. Secure the overhead structure by bolting the rear mullions tegether.
Do not use bolts
to pull cases together!
9.Apply bead of silicone to top of bulkheads and slip on stainless steel bulkhead cap. Also apply silicone to seam between overhead light tubes.
10.VERY IMPORTANT! Apply liberal amounts of black silicone to area under interior lower legs and fill all voids down to bulkhead.
11.Use finger to smooth silicone as thin as possible at masking tape on inside and outside of rear mullion (apply additional silicone if necessary). Remove tape applied on line #3.
BOLT
SEALANT
BOLT
Figure 2
DO NOT SEAL JOINT TRIM TO FLOOR!
5