 12 , Stopping Engine, Engine switch, Drilling F9

3. Operation

12 

aspect while holding the throttle lever, and set the throttle lever in the start position. (F6)

(1)Engine switch

(2)Start

(3)Stop

(4)Choke lever

(5)Open

(6)Close

(7)Primer pump

(8)Throttle lever

(9)Lock button

6.While supporting the auger with your left waist and left hand as shown in the figure, pull the starter rope, first lightly and add force when compression is felt. (F7)

WARNING

Keep the drill clear of everything around it as it will start rotating upon starting of engine.

7.When the engine has started, gradually open the choke and release the throttle lever.

8.Alow the engine to warm up for a half minutes before starting operation.

NOTE

•When re-starting immediately after stopping the engine, keep the choke open.

•If the engine won’t start after repeated attempts, it may be overfed with fuel. Remove and dry the spark plug, and try to start again with the choke open.

■STOPPING ENGINE

1.Release the throttle lever to allow the engine idling for a few minutes

2.Put the switch to the “STOP” position. (F8)

(1) Engine switch

■DRILLING (F9)

•Keep a firm grip of the auger at all times on a wide stance and by holding the handle with both