3. Operation
F1
F2
F3
F4
F5
■INSTALLING LEFT GRIP (F1)
•Screw in the left grip to the bracket provided on the frame and tighten the lock nut securely.
(1)Left grip
(2)Bracket
(3)Lock nut
■INSTALLING DRILL (F2)
1.Slide the ring clip and remove the lock pin from the drill.
2.Put the drill onto the auger output shaft and insert the lock pin. Cover it with the ring clip.
(1)PTO shaft
(2)Clip band
(3)Drill
(4)Pin
■THROTTLE CABLE PLAY (F3)
•Check the throttle cable play and adjust to 1~2mm(.04~.08in.) as necessary.
(1)Lock nut
(2)Big
(3)Small
■STARTING ENGINE
1.Fill fuel and tighten the cap securely.
2.Put the switch to “START” position. (F4)
3.Close the choke. (F5)
NOTE
When restarting immediately after stopping the engine, Ieave the choke open. (F5)
4.Push the primer pump until overflown fuel flows out in the clear tube. (F5)
NOTE
The pump operation is not necessary when restarting the engine immediately after stopping it.
5.Push the start set button of the handle left