Shutdown and Cleanup
Shutdown and Cleanup
Keep pump and hose clean when switching between simulated acoustic, knockdown and orange peel 
applications. A dirty pump can release particles of texture into the finish.
CAUTION
•To increase pump life, turn power off when not spraying.
•Before removing material hose be sure pressure is relieved and material is not in hose.
•To keep unit in good operating condition, always clean it thoroughly and prepare it properly for storage.
5.Spray inside material hopper to circulate water through gun and hose. While circulating water, use
gun to clean material hopper.
Texture Spraying (5 gallon Material Hopper)
When you have finished spraying:
1.Turn sprayer power switch (K) ON (air compressor can remain OFF).
ti9202a
2. Close gun air valve.
ti8527a
3.Trigger gun into bucket until most of texture mix is pumped out.
4.Fill material hopper with
ti8371a
6.Spray water into a waste bucket to empty material hopper.
A soft brush can be used to loosen dried on 
material.
7.Turn sprayer power switch OFF.
8.Turn air compressor ON.
9.Open gun air valve to blow out any remaining tex- ture residue. Flush with water.
CAUTION
If water freezes in unit, damage may occur. Store system where it will not freeze during cold weather.
10. Turn air compressor OFF.
Inspect slots under machine daily for texture 
material. If you find material flowing out of slots or see material inside unit, replace pump hose immediately.
11