Preparation
Preparation
Pressure Relief Procedure
To reduce risk of injury, follow this procedure whenever you see this symbol throughout this manual, Also, perform this procedure whenever you:
•Stop spraying
•Check or repair any part of this system
•Install or clean spray nozzle
1. Turn power switch (K) OFF.
ti9165a
2. Trigger gun into material hopper.
ti8371a
3. Open gun air valve.
Check with a qualified electrician or serviceman if grounding instructions are not completely understood, or if in doubt as to whether the product is properly grounded. Do not modify plug provided; if it will not fit the outlet, have proper outlet installed by a qualified electrician.
120V AC Systems
•This equipment requires a 120V AC, 60 Hz, 15A cir- cuit with a grounding receptacle. Do not use an adapter with this product.
ti2810a
Extension Cords
•Use only an extension cord with an undamaged,
•For 25 to 50 ft (7.6 to 15.2 m) cords, use
•For up to 100 ft. (30.48 m) cord, use
ti8528a
Grounding and Electrical Requirements
This sprayer must be grounded. Grounding reduces the risk of electrical shock by providing an escape wire for the electrical current. The sprayer cord includes a grounding wire with an appropriate grounding plug. The plug must be plugged into an outlet that is properly installed and grounded in accordance with all local codes and ordinances.
Additional Required Equipment
Auxiliary Air Compressor
Minimum Requirements: 3.5 CFM @ 40 psi or 2.5 CFM @ 90 psi (maximum 100 psi)
3/8 x 25 ft minimum airline rated @ 120 psi/min
Alternate Power - Generator Requirements
3500 W (3.5 kW) minimum
6