Ti9202a

8.Point gun into waste bucket and pull trigger to pump water through the system. Continue to trigger gun until material hopper is empty.

9.Install burp guard (J). Caution, page 3.

ti8376a

10.Add pre-mixed texture mix to material hopper. See Mixing Material, page 9.

Setup

11.Continue to trigger gun and spray into waste bucket until a steady stream of material sprays out of gun.

12.Turn on Air compressor and open gun valve to desired setting.

ti9775a

13.To achieve uniform spray pattern, adjust air valve and flow adjustment nut on gun. If you can not achieve a desired pattern, change nozzle, page 10.

Fluid flow will be restricted if the material hose is kinked.