Aiming Sprayer, Spray Pattern Quality

Aiming Sprayer

Aim sprayer at bottom edge of previous stroke, overlapping each stroke by half.

	ti18882a
ti18867a	ti14782a	ti18888a
	ti14782a	ti18888a

Spray Pattern Quality

A good spray pattern is evenly distributed as it hits the sur- face. Adjust pressure control knob so pressure is just high enough to spray without “tails”. If tails persist at highest pressure setting, a smaller tip is needed to spray the mate- rial or material may need to be thinned.

ti19466a	ti19502a
BAD PATTERN	GOOD PATTERN

Unclogging Spray Tip/Guard Assembly

Do not operate or spray near children. Do not aim the sprayer at, or spray any person or animal. Keep hands and other body parts away from discharge. For example, do not try to stop leaks with any part of the body.

1.To unclog spray tip clog, engage trigger lock and put prime/spray valve UP to release pressure.

ti18866a

ti16700a

2.Reverse spray tip to UNCLOG position. Turn pressure control knob to maximum pressure setting.

Getting Started with Basic Techniques

3.Aim sprayer at waste area, disengage trigger lock, and put prime/spray valve DOWN to spray position. Pull trigger to clear clog.

ti16701a

ti18874a

ti14995a

4.Engage trigger lock. Put prime/spray valve UP to release pressure and rotate spray tip back to SPRAY position.

ti14994a

ti16700ati16992a ti14999a

5.Disengage trigger lock, put prime/spray valve DOWN to spray position, and resume spraying.

ti16701a ti18874a

6.If spray tip is still clogged, you may have to repeat steps 1 - 5 and rotate the spray tip from SPRAY to UNCLOG several times. Repeat step 1 to release pressure, remove and clean spray tip filter, or replace with new spray tip/guard assembly.

ti14989a

NOTE: Spray tip filter assembly is reverse-threaded: Turn left (or counter-clockwise) to install.

Turn right (or clockwise) to remove.

NOTICE

Make sure spray tip filter is completely screwed into the spray/tip guard assembly to avoid damage to the filter. Do not use a damaged filter or poor sprayer performance may result.

7.When obstruction is cleared, engage trigger lock and rotate spray tip back to SPRAY position.

ti14991a	ti16704a
	ti18866a	ti16992a

3A2589D