Graco 3A2589D important safety instructions Troubleshooting, Problem Cause Solution

Page 27

Troubleshooting

Troubleshooting

Check everything in this Troubleshooting Table before you bring the sprayer to an authorized service center.

This equipment stays pressurized until pressure is manually relieved. To help prevent serious injury from pressurized fluid, such as skin injection, splashing fluid and moving parts, follow the Pressure Relief Procedure when you stop spraying and before cleaning, checking, or servicing the equipment.

Problem

Cause

Solution

 

 

 

 

 

 

Sprayer makes no sound when

Trigger is locked.

Disengage trigger lock. See page 7.

trigger is pulled

 

 

Sprayer status indicator light is solid

Replace with charged battery and place

 

RED when triggering, indicating that

old battery in charger, or allow battery to

 

the battery charge is low, or the bat-

warm up.

 

tery is too cold.

 

 

 

 

 

Sprayer status indicator light is flash-

Allow battery to cool.

 

ing RED when triggering, indicating

 

 

that the battery is too hot to operate.

 

 

 

 

 

Sprayer status indicator light does

Install battery or replace.

 

not light when sprayer is triggered.

 

 

Battery is not installed or is damaged.

 

 

 

 

 

Motor/control board kit has reached

Replace motor/control board kit.

 

maximum life.

 

 

 

 

3A2589D

27

Image 27
Contents Model Charger Cordless Hand-Held Paint Sprayers 3A2589DTable of Contents Fire and Explosion Hazard California Proposition Component Identification Label Appearance Description Charging the BatteryCharger Status Indicator Lights Sprayer Status Indicator LightTrigger Locked Pressure Relief ProcedureTrigger Lock Prime/Spray ValveReversible Spray Tip Pressure Control Knob Flexible Suction Tube Sprayer Setup If sprayer fails to prime, try one of the steps below Starting a New Job Or Refilling the Material CupSelecting Tip Hole Size Choosing Pressure Control Knob SettingChoosing the Correct Tip Understanding Tip NumberInstall Spray Tip/Guard Assembly if not installed Getting Started with Basic TechniquesTriggering Sprayer Unclogging Spray Tip/Guard Assembly Aiming SprayerSpray Pattern Quality Flushing Sprayer Shutdown and CleaningTi15529ati19009a Storage Cleaning Sprayer ExteriorWiring General ServiceModels 16M886, 16N657, 24R747 Replacement PartsDescription Parts List Models 16N657, 16M886, 24R747Number Model 16N660 Parts List Model 16N660 Parts List Models 16N660 Installation Inlet Valve Fitting Removal/ServiceRemoval Outlet Valve Fitting RepairProblem Cause Solution TroubleshootingRemoval/Service, Down and Cleaning,See Shutdown and Cleaning, Valve Fitting Removal/Service,See Choosing the Correct Tip, Spray Pattern Diagnostics Problem Cause SolutionTip/Guard Assembly, See Charging the Battery,Spray pattern spits at the end Troubleshooting Leaks Technical Data Battery Lithium IonMetric Date Material Spray Pressure Setting Sprayed Tip Mark Dial Preferred Material Settings LogGraco Information Graco Standard Warranty