Graco 3A2589D important safety instructions Flexible Suction Tube

Page 9

Common Procedures

Flexible Suction Tube

This sprayer comes with a flexible suction tube for multi-directional spraying without adjustment.

To ensure proper function of flexible suction tube, orient as shown. Make sure tab from sprayer is aligned with groove from flexible suction tube and firmly push into place.

NOTE: If the sprayer is angled or tilted too far, the flexi- ble suction tube will lose contact with the material and the sprayer will stop spraying.

Tab

ti18881a ti18878a

Model 16N660 only: The flexible suction tube on these models does not have an alignment groove. Orient flexi- ble suction tube screen end forward (away from trigger) as shown below and firmly push into place.

ti19463a

3A2589D

9

Image 9
Contents Model Charger Cordless Hand-Held Paint Sprayers 3A2589DTable of Contents Fire and Explosion Hazard California Proposition Component Identification Charger Status Indicator Lights Charging the BatterySprayer Status Indicator Light Label Appearance DescriptionTrigger Lock Pressure Relief ProcedurePrime/Spray Valve Trigger LockedReversible Spray Tip Pressure Control Knob Flexible Suction Tube Sprayer Setup If sprayer fails to prime, try one of the steps below Starting a New Job Or Refilling the Material CupChoosing the Correct Tip Choosing Pressure Control Knob SettingUnderstanding Tip Number Selecting Tip Hole SizeInstall Spray Tip/Guard Assembly if not installed Getting Started with Basic TechniquesTriggering Sprayer Unclogging Spray Tip/Guard Assembly Aiming SprayerSpray Pattern Quality Flushing Sprayer Shutdown and CleaningTi15529ati19009a Storage Cleaning Sprayer ExteriorWiring General ServiceModels 16M886, 16N657, 24R747 Replacement PartsDescription Parts List Models 16N657, 16M886, 24R747Number Model 16N660 Parts List Model 16N660 Parts List Models 16N660 Installation Inlet Valve Fitting Removal/ServiceRemoval Outlet Valve Fitting RepairProblem Cause Solution TroubleshootingSee Shutdown and Cleaning, Down and Cleaning,Valve Fitting Removal/Service, Removal/Service,Tip/Guard Assembly, Spray Pattern Diagnostics Problem Cause SolutionSee Charging the Battery, See Choosing the Correct Tip,Spray pattern spits at the end Troubleshooting Leaks Technical Data Battery Lithium IonMetric Date Material Spray Pressure Setting Sprayed Tip Mark Dial Preferred Material Settings LogGraco Information Graco Standard Warranty