Secondary Menu - Stored Data and WatchDog Pump Protection Modes
1.Perform Pressure Relief, steps 1 - 4 if they have not already been done.
2.Turn power switch on while holding DTS button down.
ti4266a
ti13605a
3.SERIAL NUMBER scrolls past and then serial num- ber (e.g. 00001) displays.
ti13622a |
ti7362a
4.Short press DTS button and MOTOR HOURS scrolls past and then total motor run hours are dis- played.
Digital Tracking System (Not Available on All Units)
7.Short press DTS button.
ti13608a
ti13626a
ti13614a
8.Press and hold (8 seconds) DTS button to move to WatchDog Trigger % menu. Continue to hold DTS button and Watchdog can be set to trigger at 30, 40, 50, or 60% of current sprayer pressure setting. Release DTS button when desired % is displayed. Default is 50%.
ti13618a
ti13619a
5.Short press DTS button. LAST ERROR CODE scrolls by and last error code is displayed; e.g. E=07 (see Repair manual).
ti13601a | ti13615a |
|
ti13607a
6.Press and hold DTS button to clear error code to zero.
ti13609a
ti13606a
TIA
9. Short press to move to SOFTWARE REV.
ti13613a
ti13623a
10.Short press DTS button. MOTOR ID RESISTOR scrolls by and model code number (see below).
Code Number | Models |
|
|
0 | 695 |
|
|
2 | 795 / MARK IV |
|
|
4 | 1095 / 220V MARK V |
|
|
6 | 1595 / 120V MARK V |
|
|
3A0156B | 15 |