Installation
Electrical Housing Access
Remove | Loosen |
outer two | inner two |
heater8 | heater |
bracket | bracket |
screws. | screws. |
| ti13358a |
Tilt the heater away from the pump for easier access to the screws on the cover of the electrical housing.
Electrical 
housing
ti13359a
Hose Connections
See FIG. 1, page 8.
1.Attach one end of the air hose to the gun air regula- tor (T, G40 spray guns only).
2.Attach the other end of the air hose to the air inlet at the base of the gun (G40 spray guns only).
3.Attach gun swivel (J) to the gun fluid inlet.
4.Attach one end of the fluid whip hose (K) to the gun swivel and the other end to the recirculating mani- fold.
5.Attach one blue fluid hose to the recirculating mani- fold and to the back pressure regulator (E).
6.Attach the other blue fluid hose to the recirculating manifold and to the filter (F) outlet.
7.Apply lens cover to both regulator gauge lenses.
8.Verify that suction hose fittings and drain hose fit- tings are tight.
12 | 313255K |