DataTrak Controls and Indicators
DataTrak Controls and Indicators
Key for FIG. 8
AA Runaway Limit, in cycles per minute (user settable;
| 00=OFF) | ||
AB | Lower Displacement (user settable) | ||
AC | Flow Rate Units (user settable to |
| /min, gpm [US], gpm |
| |||
| |||
| [Imperial], oz/min [US], oz/min [Imperial], l/min, or cc/min) | ||
AD | LED (fault indicator when lit) | ||
AE | Display | ||
PF | Prime/Flush Key (Enables Prime/Flush mode. While in | ||
| Prime/Flush mode, runaway protection is disabled and the | ||
| batch totalizer [BT] will not count.) LED will flash while in | ||
| Prime/Flush mode. | ||
RK Reset Key (Resets faults. Press and hold for 3 seconds to clear the batch totalizer.) Push to toggle between flow rate and cycle rate. With runaway protection enabled, push to extend and retract the solenoid pin.
CF Cycle/Flow Rate
BT Batch Totalizer
GT Grand Totalizer
RT Runaway Toggle (enable/disable) UT E1 Toggle
DT E2 Toggle
ST E5 Toggle
| GT |
AE, see details at right | Run Mode |
RK | PF |
ti8622b
CF | BT |
RT
AD | ti11883a | Setup Mode |
| UT | |||
|
|
|
| ||||
|
|
|
|
|
| ||
| AC |
|
|
|
| ||
|
|
|
|
|
|
| DT |
| AB |
|
|
|
| ||
| RK |
|
|
|
|
| PF |
|
|
|
|
|
| ||
|
|
| |||||
|
|
|
|
| ti8623b | ||
|
|
| AA |
| ST | ||
FIG. 8. DataTrak Controls and Indicators
313255K | 19 |