Graco 130HS important safety instructions Engine, Do Fan Belt, Installation

Page 14

Engine

Engine

NOTE: All service to the engine must be performed by an authorized HONDA dealer,

Removal

6.Remove four screws (189), washers (114), washers (170) and nuts (118) and remove rocker plate, dampeners (59) and washers (114) from engine.

Installation

1.Relieve pressure, page 7.

2.Do Fan Belt, Removal; page 13.

3.Loosen hand nut (241). Swing bracket (30) out.

4.F IG . 4. Disconnect red and black leads from engine.

5.Remove engine and rocker plate (87c) from sprayer.

1.Install rocker plate (87c), dampeners (59) and wash- ers (170), washers (114) on engine (185) with four screws (189), washers (170) and nuts (118); torque to 20 ft-lb (27.1 N•m).

2.Install engine and rocker plate (87c) on sprayer.

3.Connect red and black leads.

4.Do Fan Belt, Installation; page 13.

5.Swing motor retainer bracket (30) in. Tighten hand nut (241).

GREEN

RED

BLACK

			118
	241	30	170
	241	30	114
			114
			59

87c

114	TI6520b
189

FIG. 4

14

313776G

Image 14

Contents LineLazer 130 HS Contents Fire and Explosion Hazard Equipment Misuse Hazard Tip Selection Grounding SAE O-Ring InstallationGeneral Repair Information Caster Wheel MaintenancePressure Relief Procedure Troubleshooting Problem Cause SolutionOr worn and that ball seats well. Reassemble Displacement pump outlet filter if used is dirty or Removal Installation Hydraulic Pump 195 Fan Belt Do Fan Belt, Installation EngineHydraulic Motor Yoke Ti13918a Oil/Filter Change Displacement Pump Remove suction tube 34 and hoseParts LineLazer IV 130HS290 Part Description Qty Detail Torque to 90-110 in-lb Torque to 10-20 ft-lb Parts LineLazer IV 130HS Screw 138 231 Kits 193 Washer Detail a JAW Technical Data Accessories313776G Graco Standard Warranty Graco Information