Graco Inc 311053E, 288554, 288048 important safety instructions Manifold Mounting Hole Layout

Page 28

Mounting Hole Layout

Mounting Hole Layout

				0.5 in.
				(12.7 mm)
				TI8116a
0.805 in. (20.5 mm)			0.4 in.	Two M5 x 0.8 x 0.25 in.
0.805 in. (20.5 mm)			0.4 in.

				(6.3 mm) holes
				(6.3 mm) holes

0.187 in. (4.8 mm)

Remove set screws when using bottom

mounting pattern. 2.125 in. (54 mm)

1.750 in.

1.375 in. (44.5 mm)

(35 mm)

Two 0.128 diameter x

0.31in. (7.8 mm) deep holes (for alignment pin)

TI8107a

FIG. 20: Manifold Mounting Hole Layout

28

311053E

Image 28

Contents Automatic Airless Spray Guns Model 288048 ShownContents Related ManualsEquipment Misuse Hazard Pressurized Equipment Hazard Installation Ventilate Spray BoothConfigure Gun and Manifold Non-circulating SystemInstall Air Fittings Ground SystemMount Gun Reciprocating Arm Rod MountStationary Support Mount All ManifoldsSetup Manifolds 288219 KEYInstall Spray Tip Adjust Spray PatternAdjust a Streaming Tip Flush Spray GunPressure Relief Procedure OperationApply the Fluid IncorrectDaily Gun Care General System Maintenance Daily Cleaning ProcedureDaily Flushing Procedure Perform Pressure Relief Procedure,General Troubleshooting TroubleshootingProblem Cause Solution Problem Cause Solution Spray Pattern Troubleshooting Service DisassemblyService Notes Reassembly Parts Model11† Ref. only Tion Charts, PartsPart No. Description Qty TIP see GG0 Series Tip SelecDescription Qty North America and International ManifoldGG0 Series Tip Selection Charts GG0 Series Spray TipsSealer Application Tip and Air Cap Selection Charts Shower TipStreaming Tips Single Orifice Fan Pattern Spray TipsAccessories Dimensions Mounting Hole Layout Manifold Mounting Hole LayoutTechnical Data Sound Power Levels dBaTriggering Speed Sound Pressure Levels dBaGraco Standard Warranty Graco Information