Graco Inc 288048, 288554, 311053E Installation, Ventilate Spray Booth, Configure Gun and Manifold

Installation

Ventilate Spray Booth

Check and follow all National, State, and Local codes regarding air exhaust velocity requirements.

Check and follow all local safety and fire codes.

Configure Gun and Manifold

(Order manifold separately. See Accessories, page 26.)

Manifolds 241161 and 241162

The gun is supplied with an internal fluid plug (4). See FIG. 1. To use the gun in a circulating system, remove the internal plug. In a non-circulating system, leave the plug in place to minimize flush time.

Installation

Non-circulating System:

1.Apply anti-seize lubricant 222955 to the threads and mating faces of manifold (102), plug (109), and elbow (107), supplied unassembled.

2.Install an elbow (107) in one fluid port of the mani- fold (102), and a plug (109) in the other port.

3.Install the internal plug (4) in the gun fluid port on the same side as the manifold plug.

4.Connect the fluid supply line to the manifold elbow (107). See FIG. 1.

5.Install the gun on the manifold, using the four screws (14). Start the threads of all four screws, and tighten the front two screws first, and then tighten the back two screws to 65 in-lb (7.3 N•m).

1Remove when used in circulating systems.

2Replace with an elbow (107) when used in circulating systems.

Circulating System

1.Apply anti-seize lubricant 222955 to the threads and mating faces of the manifold (102) and the elbows (107), supplied unassembled.

2.Install the elbows (107) in both fluid ports of the manifold (102).

3.Connect the fluid supply line to one elbow and the fluid return line to the other. The manifold fluid ports are reversible.

5

6

102

1 4

107

109

2

TI8587b

FIG. 1: Non-Circulating Setup (Cutaway View)

311053E 5