Switch Guard Assembly

Startup

8.Hold gun against grounded metal flushing pail. Trig- ger gun and increase fluid pressure slowly until pump runs smoothly.

ti13243a

ti5796a

Inspect fittings for leaks. Do not stop leaks with your hand or a rag! If leaks occur, turn sprayer OFF immediately. Perform Pressure Relief Procedure steps 1-3, page 5. Tighten leaky fittings. Repeat Startup procedure steps 1 - 5. If no leaks, continue to trigger gun until system is thoroughly flushed. Proceed to step 6.

9. Place siphon tube in material pail.

ti5797a

10.Trigger gun again into flushing fluid pail until mate- rial appears.

ti13243a

1.Put trigger safety ON. Insert SwitchTip. Insert seat and OneSeal™.

B A

2. Insert SwitchTip.

ti13024a

3. Screw assembly onto gun. Tighten.

ti2710a

Spray

1.Spray test pattern. Increase pressure to eliminate heavy edges. Use smaller tip size if pressure adjust- ment can not eliminate heavy edges.

ti13030a

2.Hold gun perpendicular, 10-12 in. (25-30 cm) from surface. Spray back and forth. Overlap by 50%. Trig- ger gun after moving and release before stopping.

ti13025a

3A0242A