Graco Inc G30W82, 313255F, G28C18 important safety instructions Equipment Misuse Hazard

Page 4

Warnings

WARNING

EQUIPMENT MISUSE HAZARD

Misuse can cause death or serious injury.

•Do not operate the unit when fatigued or under the influence of drugs or alcohol.

•Do not exceed the maximum working pressure or temperature rating of the lowest rated system component. See Technical Data in all equipment manuals.

•Do not leave the work area while equipment is energized or under pressure. Turn off all equipment and follow the Pressure Relief Procedure in this manual when equipment is not in use.

•Check equipment daily. Repair or replace worn or damaged parts immediately with genuine manu- facturer’s replacement parts only.

•Do not alter or modify equipment.

•Use equipment only for its intended purpose. Call your distributor for information.

•Route hoses and cables away from traffic areas, sharp edges, moving parts, and hot surfaces.

•Do not kink or over bend hoses or use hoses to pull equipment.

•Keep children and animals away from work area.

•Comply with all applicable safety regulations.

MOVING PARTS HAZARD

Moving parts can pinch or amputate fingers and other body parts.

•Keep clear of moving parts.

•Do not operate equipment with protective guards or covers removed.

•Pressurized equipment can start without warning. Before checking, moving, or servicing equipment, follow the Pressure Relief Procedure in this manual. Disconnect power or air supply.

TOXIC FLUID OR FUMES HAZARD

Toxic fluids or fumes can cause serious injury or death if splashed in the eyes or on skin, inhaled, or swallowed.

•Read MSDS’s to know the specific hazards of the fluids you are using.

•Store hazardous fluid in approved containers, and dispose of it according to applicable guidelines.

•Always wear impervious gloves when spraying or cleaning equipment.

PERSONAL PROTECTIVE EQUIPMENT

You must wear appropriate protective equipment when operating, servicing, or when in the operating area of the equipment to help protect you from serious injury, including eye injury, inhalation of toxic fumes, burns, and hearing loss. This equipment includes but is not limited to:

•Protective eyewear

•Clothing and respirator as recommended by the fluid and solvent manufacturer

•Gloves

•Hearing protection

4

313255F

Page 3 Page 5
Image 4
Page 3 Page 5
Contents Model G28C18 G30W82 Ll 2 G c T2Contents Related ManualsFire and Explosion Hazard Equipment Misuse Hazard Models DataTrak has the following agency approvals II 1 GMerkur 281 Heated Packages G28Wxx and G28Cxx Merkur 301 Heated Packages G30Wxx and G30CxxMerkur 481 Heated Packages G48Wxx Installation Ventilate the Spray Booth General InformationPrepare the Operator Prepare the Site Wall Mount PackagesSupplied Components Setup GroundingElectrical Housing Access Hose ConnectionsPressure Relief Procedure Flush Before Using EquipmentOperation Trigger LockWet Cup Install the Spray TipPrime the Pump Adjust the Atomization Adjust the Spray PatternPackages with Airless Guns Packages with AA GunsIG . Spray Pattern Problems Follow Pressure Relief Procedure,Shutdown No air too little air correct AmountMaintenance Preventive Maintenance ScheduleTighten Threaded Connections Flush the PumpTroubleshooting Problem Cause SolutionDataTrak Controls and Indicators Run ModeSetup Mode Key for FIGSetup Mode Run ModeDataTrak Operation RunawayDiagnostics Prime/FlushCounter/Totalizer DisplayDiagnostic Codes Symbol Code Code Name Diagnosis CauseReplace Battery Replace DataTrak Battery or FuseReplace Fuse Parts G40 Gun Shown G28xxx Models Description QtyG30xxx Models W30CBSG48Wxx Models Description QtyKits Wall Mount Kit 24A578Heated Cart Mount Kit No. Part No. Description QtyKit 24A581 Pump and Gun Control Panel KitRef. Part Description Qty Pump Only Control Panel Kit Kit 24A583DataTrak Kits Ptfe Suction Hose KitsKit 24A576 with Runaway Protection Kit 24C580Wall Bracket Mounting Dimensions Technical DataGraco Standard Warranty Graco Information
Top Page Image Contents