American Power Conversion 68001 warranty Setup

Page 10

Notice

Clean the Sprayer IMMEDIATELY after use. Delayed or inadequate cleaning will permanently clog the

Spray Gun. Warranty void if sprayer is not properly cleaned immediately after every use.

Setup

Note: Remove or cover objects that you want to protect from overspray (paint mist).

1.Attach Paint Hose to Paint Hose Outlet and tighten with wrench.

2.Attach Paint Hose to Paint Gun and tighten with two wrenches.

3.Turn Pressure Control Knob to Low Pressure Spray setting.

Page 10

For technical questions, please call 1-800-444-3353.

SKU 68001

Image 10

Contents See Cleaning on pages Email our technical support at tech@harborfreight.comSave This Manual Use safety equipment Safety WarningsPersonal safety Operate only in a well-ventilated areaPaint Sprayer Safety Warnings Injection HazardSparks from improper grounding can ignite fumes Prong Plug and Outlet GroundingAt full load Symbology Before You Begin ON/OFFLock whenever not in use Nozzle Spray Pressure Control KnobSetup To Relieve Sprayer Pressure Priming Water-Based vs. Oil-Based Paints Oil-based Paint Priming Spray GunPriming and Startup Steps For technical questions, please call Painting Painting TechniquesClearing Spray Tip Cleaning For technical questions, please call Long Term Storage Problem Possible Causes Likely Solutions TroubleshootingDisposal Instructions Parts List Part DescriptionAssembly Diagram Limited 90 Day Warranty PLEase read the following carefullySpecifications Mission Oaks Blvd. PO Box 6009 Camarillo, CA 93011 800