American Power Conversion 68001 warranty For technical questions, please call

Page 17

Notice

Clean the Sprayer IMMEDIATELY after use. Delayed or inadequate cleaning will permanently clog the

Spray Gun. Warranty void if sprayer is not properly cleaned immediately after every use.

9. Change to waste bucket as paint thins.

13. Remove trigger guard from housing.

10. Turn to Prime mode.

14. Unscrew nut.

11. Continue to flush until clear.

15. Remove filter.

12. Release trigger, turn power off, and relieve pressure.

16.Clean all parts in warm, soapy water or flushing fluid with a bristled brush.

SKU 68001

For technical questions, please call 1-800-444-3353.

Page 17

Image 17
Contents Email our technical support at tech@harborfreight.com See Cleaning on pagesSave This Manual Personal safety Safety WarningsUse safety equipment Operate only in a well-ventilated areaInjection Hazard Paint Sprayer Safety WarningsSparks from improper grounding can ignite fumes At full load GroundingProng Plug and Outlet Symbology ON/OFF Before You BeginPressure Control Knob Lock whenever not in use Nozzle SpraySetup To Relieve Sprayer Pressure Priming and Startup Steps Priming Spray GunPriming Water-Based vs. Oil-Based Paints Oil-based Paint For technical questions, please call Painting Techniques PaintingClearing Spray Tip Cleaning For technical questions, please call Long Term Storage Disposal Instructions TroubleshootingProblem Possible Causes Likely Solutions Part Description Parts ListAssembly Diagram PLEase read the following carefully Limited 90 Day WarrantySpecifications Mission Oaks Blvd. PO Box 6009 Camarillo, CA 93011 800