American Power Conversion 68001 warranty To Relieve Sprayer Pressure

Page 11

Notice

Clean the Sprayer IMMEDIATELY after use. Delayed or inadequate cleaning will permanently clog the

Spray Gun. Warranty void if sprayer is not properly cleaned immediately after every use.

To Relieve Sprayer Pressure

4. Turn Trigger Lock Knob to Locking position.

1. Turn Power Switch off and unplug unit from outlet.

5. Switch Prime/Spray switch to Prime mode.

2. Switch Prime/Spray switch to Prime mode.

3.Point gun into paint pail and activate Sprayer Trigger to relieve pressure.

SKU 68001

For technical questions, please call 1-800-444-3353.

Page 11

Image 11

Contents Email our technical support at tech@harborfreight.com See Cleaning on pagesSave This Manual Operate only in a well-ventilated area Safety WarningsPersonal safety Use safety equipmentInjection Hazard Paint Sprayer Safety WarningsSparks from improper grounding can ignite fumes At full load GroundingProng Plug and Outlet Symbology ON/OFF Before You BeginPressure Control Knob Lock whenever not in use Nozzle SpraySetup To Relieve Sprayer Pressure Priming and Startup Steps Priming Spray GunPriming Water-Based vs. Oil-Based Paints Oil-based Paint For technical questions, please call Painting Techniques PaintingClearing Spray Tip Cleaning For technical questions, please call Long Term Storage Disposal Instructions TroubleshootingProblem Possible Causes Likely Solutions Part Description Parts ListAssembly Diagram PLEase read the following carefully Limited 90 Day WarrantySpecifications Mission Oaks Blvd. PO Box 6009 Camarillo, CA 93011 800