American Power Conversion 68001 warranty Cleaning

Page 16

Notice

Clean the Sprayer IMMEDIATELY after use. Delayed or inadequate cleaning will permanently clog the

Spray Gun. Warranty void if sprayer is not properly cleaned immediately after every use.

Cleaning

5. Unthread Spray Tip and remove.

1. Relieve pressure and drain paint from Tubes.

6. Turn to Spray mode.

2. Separate tubes.

7. Switch power to on.

3. Place Return Tube in empty waste bucket.

8. Spray paint into paint pail.

4. Submerge Suction Tube in water or flushing fluid.

Page 16

For technical questions, please call 1-800-444-3353.

SKU 68001

Image 16

Contents See Cleaning on pages Email our technical support at tech@harborfreight.comSave This Manual Safety Warnings Personal safetyUse safety equipment Operate only in a well-ventilated areaPaint Sprayer Safety Warnings Injection HazardSparks from improper grounding can ignite fumes Prong Plug and Outlet GroundingAt full load Symbology Before You Begin ON/OFFLock whenever not in use Nozzle Spray Pressure Control KnobSetup To Relieve Sprayer Pressure Priming Water-Based vs. Oil-Based Paints Oil-based Paint Priming Spray GunPriming and Startup Steps For technical questions, please call Painting Painting TechniquesClearing Spray Tip Cleaning For technical questions, please call Long Term Storage Problem Possible Causes Likely Solutions TroubleshootingDisposal Instructions Parts List Part DescriptionAssembly Diagram Limited 90 Day Warranty PLEase read the following carefullySpecifications Mission Oaks Blvd. PO Box 6009 Camarillo, CA 93011 800