Unigreen CAMPO 11 - 16 - 22 - 32 manual Manual Premixing, Premixer on Cover Optional, Max 15 Bar

Page 15

=with the stirrer on a delivery, run the pump supplying the stirrer (or ejector) at the maximum pressure available for at least 10-15 minutes. (FIG. N° 7)

Some models with very small tanks aren’t equipped with mixers, you should use the drain of the pressure regulator: run the pump at roughly 540 RPM with the pressure regulator in the drain position for at least 10-15 minutes. (FIG. N° 9).

4.12.1 MANUAL PREMIXING

Dilute the active principle by hand before introducing it into the tank, (you must wear suitable protective clothing such as rubber gloves, a mask or goggles, overalls, etc.).

FIG. 9

WARNING: using the taps on the pump or in any case on the front of the machine puts the operator near the cardan shaft. Despite the presence of CE standard protective covers you should take great care.

4.12.2 PREMIXER ON COVER (OPTIONAL):

Open the cover and pour all of the chemical powder into the filter, close the cover and open the supply tap until all of the powder has dissolved.

4.12.3PREMIXER ON HOPPER WITH TIN WASHER (OPTIONAL) Premixers are available on request, such as the FULL-MIX 40 (FIG. N° 10), to mix the product in the tank proceed as follows:

= check that all the taps of the premix are closed and open the supply tap on the sprayer, delivering liquid at a pressure of roughly 10-12 bar (never exceed 15 bar).

= press lever 4 for a few seconds introducing 3-4 litres of water into the hopper.

= open the premix, overturning the cover as shown in the photo and introdu- ce the product to mix into the hopper 1, close the cover again.

= press lever 4 to mix the product in the hopper, watching the level of the liquid which could overflow. To prevent overflowing and to help powder products dissolve, open tap 6) to drain into the tank.

= after emptying, close tap 6.

To wash the tin, proceed as follows:

=open the premix, overturning the cover as shown in the photo

=supply the premix using the control to regulate a pressure to under 3-4 bar

=introduce the tin into the hopper, insert washing pipe 2 into the tin, press the tin onto the pipe until it has been completely washed.

=open tap 6 to drain into the tank at the same time.

=after emptying, close tap 6.

NB: If the tin washer isn’t supplied with clean water and isn’t fitted with the optional electrical pump, you must rinse again by hand with clean water.

THE LIQUIDS USED FOR RINSING SHOULD BE INTRODUCED INTO THE TANK AND BE SPRAYED ON THE FIELD.

At the end of the operations, wash the hopper:

=check that the cover and all the taps of the premix are closed and open the supply tap on the sprayer, delivering liquid at a pressure of roughly 10-12 bar (never exceed 15 bar).

=open safety tap 10.

=press lever 4 to activate jets 3 and 9, watching the level of the liquid which could overflow. To prevent overflowing, open tap 6) to drain into the tank.

=after washing, release lever 4 and close taps 6 and 10.

There is also a version of the premixer, similar to the one described, equipped with an independent pressure regulator that is connected directly to the pump, called TOP MIX, the functional character of which is described below.

FULL-Mix 40

FIG. N°10

10

9

1

2

4

3

Max 15 Bar 6

ALLA CISTERNA

TO THE TANK

unigreen 15

Page 14 Page 16
Image 15
Page 14 Page 16
Contents 09/2006 USE and Maintenance ManualSummary PROBLEMS, Causes and Solutions Product Responsibility Unigreen spa is not responsible if GuaranteeComposition of the Manual Improper useKey to the symbols Recommendations Using Chemical ProductsIntended USE Prohibited USEDriving on the Road Machines Designed to be Used only with Clean WaterCharacteristics and Specifications Weather ConditionsHand Washingtanks Noise Level of the MachineStandards of Reference USER’S Instructions Description of the MachinePreliminary Checks Transporting and Moving the MachineTowed Sprayers Tractor Coupling Hydraulic Connection to the DistributorsCardan Shaft Suction Filter PumpGeneral Instructions Pressure RegulatorComponents of the Pressure Regulator Control box for Ergo and Remo electrical regulatorsSpraying Computer Optional Mixing Filling the TankManual Premixing Premixer on Cover OptionalMax 15 Bar TOP-MIX Premixer Version Optional Washing the SprayerCircuit Washer Andtank Washer OIL Feed from Tractor Indipendent Hydraulic PlantAIR-ASSISTED Booms SELF-LEVELING DevicesVariable Geometry Anti-drift nozzles LiftingDescription of Type of Nozzles Fan nozzles=600xQ Useful InformationHand Lances MaintenanceProgrammed Maintenance TAB. N MarkerStorage in a Warehouse and Transportation Routine MaintenanceExtraordinary Maintenance RepairsElectrical and Electronic Apparatus Waste Eeaw Putting Back Into Service After Winter LayupDemolition and Disposal Materials for DemolitionArancio Orange Verde Green Giallo Yellow BLU Blue Rosso RED TAB.1 Characteristics Nozzles ISORosso RED Marrone Brown TAB.2 Characteristics Nozzles Conical ISOTAB.4-5 Capacity Hand Lances TAB.5-6 Spraying Tables 2500Table of Programmed Maintenance Operation PROBLEMS, Causes and Solutions50 h 300 h TAB a TAB.12A Allowed FittingsTAB.12B Allowed Fittings TAB bIL Polietilene Rotazionale Member of the group
Related manuals
Manual 36 pages 31.8 Kb

CAMPO 11 - 16 - 22 - 32, DSP 11 - 16 - 22 - 32 specifications

Unigreen DSP Series and CAMPO Series are advanced agricultural sprayers designed to meet the evolving needs of modern farming. The Unigreen DSP (Dynamic Spraying Product) models 11, 16, 22, and 32, along with the CAMPO models of the same specifications, are engineered for efficiency, precision, and reliability in crop protection.

One of the key features of the Unigreen DSP models is their innovative spraying technology. Each model is equipped with a high-capacity tank that allows for extended operation without the need for frequent refills. The DSP series incorporates adjustable booms that provide precise application across various crop types. This ensures uniform coverage and minimizes waste, making it an environmentally friendly option for farmers.

The CAMPO series also boasts similar tank capacities and boom adjustments, making them suitable for diverse agricultural applications. Both series offer customizable options, allowing farmers to choose the configuration that best fits their land and crop requirements.

Another standout characteristic of both Unigreen and CAMPO sprayers is their user-friendly interface. Equipped with advanced electronic controls, farmers can easily monitor and adjust spray rates, pressure, and other critical parameters in real time. This technology not only enhances the sprayers' operational efficiency but also aids in achieving the optimum application rates for different pesticides and fertilizers.

Furthermore, both series integrate cutting-edge GPS technology, enabling precision agriculture practices. This feature allows operators to map their fields, ensuring that every inch is accurately treated, while also reducing the possibility of overlap or missed areas. This precision application reduces chemical usage and ultimately leads to cost savings.

Durability is another primary focus in the design of the Unigreen DSP and CAMPO sprayers. Built with high-quality materials that can withstand harsh environmental conditions, these sprayers promise longevity and consistent performance over time.

In summary, Unigreen DSP and CAMPO models 11, 16, 22, and 32 are technologically advanced agricultural sprayers that combine efficiency, precision, and durability. With features such as adjustable booms, advanced electronic controls, and GPS technology, they cater to the diverse needs of today’s farmers, helping to enhance productivity while minimizing environmental impact. These sprayers are positioned to play a pivotal role in the future of sustainable agriculture.
Top Page Image Contents