Accessories
The tool is supplied with the following accessories:
-4mm Hex key
-Chuck Key
Unpacking
Carefully remove all parts from the packaging and check that they are in good condition.
Check that the following parts are supplied.
Bags of fittings comprising:
-4mm hex key
-Belt tension lock knob
-Support lock
-3 x 8mm x 20mm bolts
-3 x feed handles
-Keyed chuck
-Chuck key
-Collar stop
-Collar screw
-Collar nut
We recommend that you purchase your accessories in the store from where you purchased the tool. Use good quality accessories and the brand recommended by the vendor.
Assembly
The following tools are required to assemble the drill press
•4mm hex key (supplied)
•Wrench (not supplied)
•Phillips head screwdriver (not supplied)
Assembly time
The DP2 drill press will take approximately 15 minutes to assemble.
IMPORTANT. If any parts are missing , please contact the place of purchase. DO NOT attempt to operate the machine until the missing parts are available.
WARNING. Ensure the machine is disconnected from the mains plug at all times during assembly and maintenance.
Place the base (8) on a flat surface.
Place the column support (6) on base and align the 3 holes in the column support with the holes in the base (8).
Using the 3 x 8mm diameter x 20mm long column support bolts secure the column support to the base and tighten with a wrench (not supplied).
Slide the table assembly (10) onto the column (5).
Install the support lock (9) handle, from the right side into the rear of the table support (10) and tighten by hand. Once tightened, ensure the table is fixed and cannot move.
8