Note. When fitting belts it is easier to place the belt onto the small pulley and then turn it onto the larger pulley.
Unscrew the screw from the pulley cover knob (21) and place it through the hole on the right side of the pulley cover (1) and tighten.
Rotate the handle in an
Raise/Lower the table support to the desired height.
Tighten the support lock to secure the table.
To apply tension to the belt, loosen the belt tension lock knob
(2)and push the motor housing backwards. Tighten belt tension lock knob.
Replace and secure the pulley cover.
Adjusting the table height
CAUTION. Always ensure that the drill press is switched off and the plug is removed from the power point before making
any adjustments.
Loosen the support lock (9).
Adjusting the table angle
CAUTION. Always ensure that the drill press is switched off and the plug is removed from the power point before making any adjustments.
Loosen the screw under the table by rotating it in an anti- clockwise direction.
Tilt the table to the desired angle as indicated on the bevel scale.
Tighten the screw under the table by rotating it in a clockwise direction.
10