Senco PC2016 operating instructions Preparation, Initial SET-UP, Location, Electrical

Page 10

PREPARATION

INITIAL SET-UP:

1.Read safety warnings before setting-up air compressor.

2.Ensure the oil level in the air compressor pump is adequate. The oil level should be at the center of the oil sight glass. If low, add Senco® part number PC0344 compressor pump oil.

LOCATION:

CAUTION

In order to avoid damaging the air compressor, do not incline the air compressor transversely or longitudinally more than 10°.

1.Place air compressor at least 12 inches away from obstacles that may prevent proper ventilation. Do not place air compressor in an area:

-where there is evidence of oil or gas leaks.

-where flammable gas vapors or materials may be present.

WARNING

Serious injury or death may occur if electrical sparks from motor and pressure switch come in contact with flammable vapors, combustible dust, gases or other combustible materials. When using the air compressor for spray painting, place the air compressor as far away from the work area as possible, using extra air hoses instead of extension cords.

-where air temperatures fall below 32°F or exceed 104°F.

-where extremely dirty air or water could be drawn into the air compressor.

ELECTRICAL:

DANGER

Improper connection of the equipment-grounding conductor can result in a risk of shock or electrocution. Check with a qualified electrician or service personnel if you are in doubt as to whether the outlet is properly grounded. Do not use any type of adapter with this product. If repair or replacement of the cord or plug is necessary, do not connect the grounding wire to either flat blade terminal. The wire with insulation having an outer surface that is green with or without yellow stripes is the grounding wire.

WARNING

This product must be grounded. If there should be a malfunction or breakdown, grounding provides a path of least resistance for electric current to reduce the risk of electric shock. This product is equipped with a cord having an equipment-grounding conductor and a grounding type plug. The plug must be plugged into an appropriate outlet that is properly installed and grounded in accordance with all local codes and ordinances.

1.Senco® DOES NOT RECOMMEND THE USE OF EXTENSION CORDS as this can create power loss and overheating of the motor. Use of an additional air hose is recommended rather than an extension cord. If use of an extension cord is unavoidable, it should be plugged into a GFCI found in circuit boxes or protected receptacles. When using an extension cord, observe the following:

Cable Length

Wire Gauge

Up to 25 feet

12 AWG

Up to 100 feet

10 AWG

Up to 150 feet

8 AWG

Up to 250 feet

6 AWG

Use only 3-blade extension cords that have 3-blade grounding-type plugs and 3-slot cord connectors that will accept the plug from the product. Use only extension cords having an electrical rating not less than the rating of the product. Do not use damaged extension cords. Examine extension cord before using and replace if damaged. Do not abuse extension cord and do not yank on any cord to disconnect. Keep cord away from heat and sharp edges. Always shut off the air compressor switch before removing the plug from the receptacle.

10

Senco® Electric Air Compressor Manual 2004

Image 10
Contents PC2016 Electric Air Compressor Table of Contents Introduction Safety AlertInspection Electric Shock Safety WarningsHazard Potential Consequence Prevention Risk ElectrocutionExplosion or Fire BurstingBurns Hazard Potential Consequence Prevention Risk toBreathing Flying ObjectsNegligence Potential Consequence Prevention Hazard Risk fromMoving Parts AIR CompressorPC2016 Electric AIR Compressor Features PC2016 Features Review Location PreparationInitial SET-UP ElectricalOperation MaintenancePRE-START Checklist ShutdownTroubleshooting Probable Cause RemedyProbable Cause Insufficient pressure at air tool or accessory Specifications Senco Compressor and Parts Warranty Compressor Warranty